AEG L60640- User Manual

5 4 3 1 2 6 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle 4 Rating plate 5 Drain pump 6 Adjustable feet 3.1 Detergent dispenser drawer Compartment for prewash phase or stain remover.The prewash detergent is added at thebeginning of the wash programme.The stain remover is added d...

poured into the compartment beforestarting the wash programme. 3.2 Child safety device Make sure that children or pets do notclimb into the drum. To prevent childrenor pets becoming trapped inside thedrum the machine incorporates a specialfeature. To activate this device, rotatethe button (without p...

After having pressed the button 7 , the FUNCTIONING pilot light ( 8.1 ) comes on.When the pilot light 8.1 comes on this means that the machine is operating.The DOOR pilot light ( 8.2 ) indicates if the door can be opened:• light on: the door cannot be opened • light blinking: the door is opening• li...

8. DAILY USE 8.1 Load the laundry 1. Open the door by carefully pullingthe door handle outwards. Place thelaundry in the drum, one item at atime, shaking them out as much aspossible. 2. Close firmly the door. You must heara click during closing. WARNING! Do not embed the laundry be-tween the door an...

• When the programme has finished the display shows a blinking . The pilotlight 8.2 goes off . The door can now be opened. Turn the programme selector dial to theposition to switch the machine off. Remove the laundry from the drum andcarefully check that the drum is empty. Ifyou do not intend to car...

10. CONSUMPTION VALUES Programme Energy consump- tion (KWh) Water consump- tion (litres) Programme du- ration (Minutes) White Cottons 95° 2.00 61 For the duration of the pro- grammes, please refer to the dis- play on the con- trol panel. Cottons 60° 1.30 58 Cotton Eco 60° 1) 1.02 54 Cottons 40° 0.70...

WARNING! When the appliance is in use and de-pending on the programme selectedthere can be hot water in the pump.Never remove the pump cover during awash cycle, always wait until the appli-ance has finished the cycle, and is emp-ty. When refitting the pump cover, en-sure it is securely re-tightened ...

to the bowl. When the bowl is full,put the cap back on the hose. Emptythe bowl. Repeat the procedure untilwater stops flowing out; 6. clean the pump if necessary as previ-ously described; 7. replace the emergency emptyinghose in its seat after having pluggedit; 8. screw the pump again and close thed...

Problem Possible cause/Solution The washing machine does not start: The door has not been closed. • Close firmly the door.The plug is not properly inserted inthe power socket.• Insert the plug into the power sock- et. There is no power at the socket.• Please check your domestic electri- cal installa...

Problem Possible cause/Solution The machine does not empty and/ordoes not spin: The drain hose is squashed or kinked. • Check the drain hose connection.The drain filter is clogged. • Clean the drain filter.An option or a programme that endswith the water still in the tub or a thateliminates all the ...

Problem Possible cause/Solution Spinning starts late or the machinedoes not spin: The electronic unbalance detectiondevice has cut in because the laundryis not evenly distributed in the drum.The laundry is redistributed by reverserotation of the drum. This may hap-pen several times before the unbal-...

Electrical connection VoltageOverall powerFuseFrequency 230 V2200 W10 A50 Hz Water supply pressure MinimumMaximum 0,5 bar (0,05 MPa)8 bar (0,8 MPa) Level of protection against ingress of solid particlesand moisture IPX4 Water supply 1) Cold water Maximum Load Cotton 6 kg Spin Speed Maximum 1000 rpm ...

3. Unscrew the three bolts with the keysupplied with the appliance. 4. Slide out the relevant plasticspacers. 5. Open the porthole and remove thepolystyrene block fitted on the doorseal. 6. Fill the smaller upper hole and thetwo large ones with the correspond-ing plastic plug caps supplied in thebag...

This could be done by tying it to thetap with a piece of string or attach-ing it to the wall. 2. In a sink drain pipe branch. This branch must be above the trap sothat the bend is at least 60 cm abovethe ground. 3. Directly into a drain pipe at aheight of not less than 60 cm and not more than 90 cm....