Page 2 - Visit our website for:; CUSTOMER CARE AND SERVICE; Downloaded From WashingMachine-Manual.com Manuals
CONTENTS 1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. TECHNICAL INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 3. PRODUCT DESCRIPTION . . . . . . . ....
Page 3 - SAFETY INFORMATION
1. SAFETY INFORMATION Before the installation and use, read thismanual carefully:• For your safety and the safety of your property • To help the environment• For the correct operation of the appli- ance. Always keep these instructions with theappliance also if you move or give it to adifferent perso...
Page 4 - TECHNICAL INFORMATION; Dimensions
• Do not install and connect a damaged appliance. • Make sure to remove all packaging and transport bolts. • Make sure that the mains plug is dis- connected from the mains socket dur-ing installation. • Only a qualified person must do the electrical installation, the plumbingand the installation of ...
Page 5 - PRODUCT DESCRIPTION
Water supply pressure Minimum 0,5 bar (0,05 MPa) Maximum 8 bar (0,8 MPa) Water supply 1) Cold water Maximum load Cotton 8 kg Spin speed Maximum 1600 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 3. PRODUCT DESCRIPTION 1 2 3 8 9 5 6 7 4 10 11 12 1 Worktop 2 Detergent dispens...
Page 6 - ACCESSORIES; Spanner; Plastic caps; Plastic hose guide; CONTROL PANEL; Programme knob
4. ACCESSORIES 1 2 3 4 1 Spanner To remove the transit bolts. 2 Plastic caps To close the holes on the rear sideof the cabinet after the removal ofthe transit bolts. 3 Anti-flood inlet hose To prevent possible leakage 4 Plastic hose guide To connect the drain hose on theedge of a sink. 5. CONTROL PA...
Page 7 - AUTO Off button
6.1 AUTO Off button 1 Press this button to activate or deacti-vate the appliance. A tune sounds whenthe appliance is activated.The AUTO OFF function automaticallydeactivates the appliance to stop the en-ergy consumption when:• You do not use the appliance for 5 mi- nutes before you press button 4 . ...
Page 9 - Err; Delay start button; STAIN
If you make a wrong selection the message Err indicates that the selec- tion is not possible. J The time save symbol comes on when you set one of theprogramme duration: • Shortened duration • Extra Quick K The extra rinse symbol comes on when this function is acti-vated. The value shows the total nu...
Page 11 - PROGRAMMES; Functions; Straufrítt; TIME SAVE; Straulétt; TIME SAVE
7. PROGRAMMES ProgrammeTemperature Type of loadMax. weight of load Cycledescrip-tion Functions Aðalþvottur 95° - Cold White and coloured cottonwith normal soil.max. load 8 kg WashRinsesLongspin SPIN REDUC-TIONRINSE HOLDPREWASH 1) EXTRA RINSESTAIN 2) TIME SAVE 3) Aðalþvotturhljóðlátt 95° - Cold White...
Page 12 - Skolun; EXTRA RINSE
ProgrammeTemperature Type of loadMax. weight of load Cycledescrip-tion Functions Ofnæmisvörn 60° White cotton items.This programme removes mi-cro-organisms thanks to thewashing by 60° C and addsone rinse. In this way thewash is more effective.Put a special additive for hy-giene in the Stain compart-...
Page 13 - Cotton and synthetic items; CONSUMPTION VALUES
3) If you set the Extra Quick duration, we recommend that you reduce the maximum load. It is possible to load fully the appliance, however the washing results are reduced. 4) The wash and spin phase is soft to prevent the creases of the laundry. The appliance adds some rinses. 5) The default phase o...
Page 14 - BEFORE FIRST USE
Programmes Load (Kg) Energy con- sumption (kWh) Water con- sumption (li- tre) Approxi- mate pro- gramme duration (minutes) Remaining moisture (%) 1) Cottons 60°C 8 1.50 66 179 43 Cottons 40°C 8 0.90 66 175 43 Synthetics 40°C 4 0.60 48 110 35 Delicates 40°C 4 0.70 58 91 35 Wool/Handwash 30 °C 2 0.35 ...
Page 15 - LOADING THE LAUNDRY; FILLING DETERGENT AND ADDITIVES
11. LOADING THE LAUNDRY 1. Open the appliance door. 2. Put the laundry in the drum, oneitem at a time. Shake the items be-fore you put them in the appliance. Make sure not to put too much laun-dry in the drum. 3. Close the door. Make sure that no laundry stays betweenthe seal and the door. There is ...
Page 16 - This is the maximum level for the quantity of liquid additives.; Check the position of the flap
This is the maximum level for the quantity of liquid additives. The compartment for the stain remover.Put the product in the compartment and set the stain functionbefore you start the programme. Flap for powder or liquid detergentTurn it (up or down) in the correct position to use powder or liq-uid ...
Page 17 - SETTING AND STARTING A PROGRAMME; Interrupt a programme; Steam
5. Measure out the detergent and thefabric conditioner. 6. Carefully close the detergent dis-penser. Make sure that the flapdoes not cause a blockage whenyou close the drawer. 13. SETTING AND STARTING A PROGRAMME 1. Turn the programme knob. The rela-ted programme indicator comes on. 2. The indicator...
Page 18 - To open the appliance door:; AT THE END OF THE PROGRAMME
13.5 Cancel the delay start 1. Press button 4 . The related indica- tor flashes. 2. Press button 5 again and again un- til the display shows 0’ . 3. Press button 4 . The programme starts. 13.6 Open the door While a programme or the delay startoperates, the appliance door is locked. To open the appli...
Page 19 - HINTS AND TIPS; The laundry load
15. HINTS AND TIPS 15.1 The laundry load • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash together white and col- oured items. • Some coloured items can discolour with the first wash. We recom...
Page 20 - CARE AND CLEANING; Descaling; Door seal
Water hardness table Level Type Water hardness °dH °T.H. mmol/l Clarke 1 soft 0-7 0-15 0-1.5 0-9 2 medium 8-14 16-25 1.6-2.5 10-16 3 hard 15-21 26-37 2.6-3.7 17-25 4 very hard > 21 > 37 >3.7 >25 16. CARE AND CLEANING WARNING! Disconnect the appliance from the mainssupply before you clean...
Page 21 - Detergent dispenser; To clean the dispenser:; Drain pump
16.6 Detergent dispenser To clean the dispenser: 1 2 1. Press the lever. 2. Pull the dispenser out. 3. Remove the top part of the liquidadditive compartment. 4. Clean all the parts with water. 5. Clean the dispenser recess with abrush. 6. Put back the dispenser in the recess. 16.7 Drain pump Regular...
Page 22 - To clean the drain pump:
To clean the drain pump: 1. Open the drain pump door. 2. Pull the flap out to remove it. 3. Put a container below the recess ofthe drain pump to collect the waterthat flows out. 4. Press the two levers and pull for-ward the drainage duct to let thewater flow out. 1 2 5. When the container is full of...
Page 23 - To clean the water inlet filters:; Emergency drain
1 2 9. Clean the filter under the water tapand put it back in the pump into thespecial guides. 10. Make sure that you tighten correctlythe filter to prevent leakages. 11. Put the flap back and close the drainpump door. 16.8 The inlet hose filter and the valve filter It could be necessary to clean th...
Page 24 - Frost precautions; TROUBLESHOOTING; Problem; The water tap is closed.
Put the drainage duct back and close thedrain pump flap.When you drain the water with the emer-gency drain procedure, you must acti-vate again the drain system: 1. Put 2 litres of water in the main washcompartment of the detergent dis-penser. 2. Start the programme to drain thewater. 16.10 Frost pre...
Page 26 - The load is very small.; INSTALLATION; Fixing plate kit
Problem Possible cause Possible solution Leakages from the drainpump. Make sure that the drain pumpfilter is tight. The water drain hose isdamaged. Make sure that the water inlethose has no damages. You cannot openthe appliancedoor. The washing pro-gramme is in operation. Let the washing programmeen...
Page 27 - Unpacking
18.2 Unpacking 1. Use the gloves. Remove the externalfilm. If necessary, use a cutter. 2. Remove the cardboard top. 3. Remove the polystyrene packagingmaterials. 4. Remove the internal film. 5. Open the door. Remove the poly-styrene piece from the door sealand all the items from the drum. ENGLISH 27...
Page 29 - Positioning and levelling
12. Put the plastic caps in the holes.You can find these caps in the usermanual bag. WARNING! Remove all the packaging andthe transit bolts before you installthe appliance. We recommend that you keepthe packaging and the transitbolts for when you move the ap-pliance. 18.3 Positioning and levelling x...
Page 30 - The inlet hose; Water drainage
18.4 The inlet hose 20 O 20 O 20 O 45 O 45 O 45 O • Connect the hose to the appliance. Turn the inlet hose only left or right.Loose the ring nut to set it in the cor-rect position. • Connect the water inlet hose to the cold water tap with 3/4 thread. CAUTION! Make sure that there are no leaksfrom th...
Page 32 - ENVIRONMENT CONCERNS
You can extend the drain hose tomaximum 400 cm. Contact theservice centre for the other drainhose and the extension. 19. ENVIRONMENT CONCERNS Recycle the materials with thesymbol . Put the packaging inapplicable containers to recycle it.Help protect the environment andhuman health and to recycle was...
