Page 2 - SERVICE; General information and tips; CONTENTS
SERVICE When contacting Service, ensure thatyou have the following data available.The information can be found on therating plate. ModelPNCSerial Number The following symbols are used in thisuser manual: Warning - Important Safety information. General information and tips Environmental information S...
Page 4 - SAFETY INFORMATION; GENERAL SAFETY
SAFETY INFORMATION Before the installation and use, readthis manual carefully:• For your safety and the safety of your property • To help the environment• For the correct operation of the ap- pliance. Always keep these instructions with theappliance also if you move or give it toa different person.T...
Page 6 - ENVIRONMENT CONCERNS; PACKAGING MATERIALS; TECHNICAL INFORMATION
ENVIRONMENT CONCERNS PACKAGING MATERIALS Recycle the materials with the symbol . Put the packaging in applicable con-tainers to recycle it. ECOLOGICAL HINTS To help the environment, use less waterand energy, obey these instructions:• Set a programme without the pre- wash phase to wash laundry with n...
Page 7 - Spanner
PRODUCT DESCRIPTION 1 2 3 5 6 7 4 8 10 11 12 9 1 Worktop 2 Detergent dispenser 3 Control panel 4 Door handle 5 Rating plate 6 Drain pump 7 Feet for the appliance level 8 Water drain hose 9 Water inlet valve 10 Mains cable 11 Transit bolts 12 Feet for the appliance level ACCESSORIES 1 2 3 4 1 Spanner...
Page 8 - CONTROL PANEL; Startuitstel; ON OFF BUTTON
CONTROL PANEL 1 2 3 4 5 6 7 8 9 1 On/Off button ( Aan/Uit ) 2 Programme knob 3 Display 4 Start/Pause button ( Start/Pauze ) 5 Delay start button ( Startuitstel ) 6 Time saving button ( Tijd Besparen ) 7 Extra rinse button ( Extra Spoelen ) 8 Spin button ( TPM ) 9 Temperature button ( Temp. °C ) ON O...
Page 9 - If the programme is completed but the symbol stays on:; DELAY START BUTTON
The display shows: A • The programme time When the programme starts, the time decreases with steps of 1 minute. • The delay start When you press the delay start button, the display shows the delay starttime. • Alarm codes If the appliance has a malfunction, the display shows alarm codes. Referto 'Tr...
Page 11 - PROGRAMMES
PROGRAMMES ProgrammeTemperature Type of loadmax. weight of load Cycledescription Functions Katoen95° - Cold White and colouredcotton with normalsoil.max. 6 kg WashRinsesLong spin SPIN REDUCTIONRINSE HOLDEXTRA SPOELENTIJD BESPAREN 1) Katoen + Voor-was95° - Cold White and colouredcotton with heavy soi...
Page 12 - CONSUMPTION VALUES
ProgrammeTemperature Type of loadmax. weight of load Cycledescription Functions Gordijnen40° - Cold Set this programmeto wash curtains. Itadds automaticallythe prewash phase toclean the dust fromthe curtains.Do not put the deter-gent into the prewashcompartment.max. 2 kg PrewashWashRinsesShort spin ...
Page 14 - Press button; LOADING THE LAUNDRY; Open the appliance door.
BEFORE FIRST USE 1. To activate the drain system, put 2litre of water in the main wash com-partment of the detergent dispens-er. 2. Put a small quantity of detergent inthe main wash compartment of the detergent dispenser. Set and starta programme for cotton at thehighest temperature without laun-dry...
Page 15 - FILLING THE DETERGENT AND ADDITIVES; This is the maximum level for the quantity of liquid additives.; Check the position of the flap
FILLING THE DETERGENT AND ADDITIVES The detergent compartment for the prewash phase, the soak pro-gramme and for the stain function.Add the detergent for prewash, soak and stain remover beforethe start of the programme. The detergent compartment for the washing phase.If you use a liquid detergent, p...
Page 16 - SETTING AND STARTING A PROGRAMME; INTERRUPT A PROGRAMME
3. To use powder detergent, turn theflap up. 4. To use liquid detergent, turn theflap down. With the flap in the positionDOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid deter- gent than the limit showed inthe flap. – Do not set the prewash phase. – Do not set the d...
Page 17 - Steam; CANCEL THE DELAY START; AT THE END OF THE PROGRAMME
CHANGE A FUNCTION You can change only some functionsbefore they operate. 1. Press button 4 . The indicator flashes. 2. Change the function set. SET THE DELAY START 1. Press button 5 again and again until the display shows the numberof minutes or hours. 2. Press button 4 , the appliance starts the co...
Page 19 - HINTS AND TIPS; THE LAUNDRY LOAD
HINTS AND TIPS THE LAUNDRY LOAD • Divide the laundry in: white, col- oured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash together white and col- oured items. • Some coloured items can discolour with the first wash. We recommendtha...
Page 20 - Water hardness table
Water hardness table Level Type Water hardness °dH °T.H. mmol/l Clarke 1 soft 0-7 0-15 0-1.5 0-9 2 medium 8-14 16-25 1.6-2.5 10-16 3 hard 15-21 26-37 2.6-3.7 17-25 4 very hard > 21 > 37 >3.7 >25 20
Page 21 - CARE AND CLEANING; DESCALING; gramme; DOOR SEAL; • Clean the drum with special product
CARE AND CLEANING WARNING! Disconnect the appliance from themains supply before you clean it. DESCALING The water we use contains limescale. Ifit becomes necessary, use a water soft-ener to remove limescales.Use a special product made for wash-ing machines. Obey the instructionsthat you find on the ...
Page 22 - DETERGENT DISPENSER; To clean the dispenser:; Pull the dispenser out.; DRAIN PUMP; • The display shows an alarm code be-
DETERGENT DISPENSER To clean the dispenser: 1 2 1. Press the lever. 2. Pull the dispenser out. 3. Remove the top part of the liquidadditive compartment. 4. Clean all the parts with water. 5. Clean the dispenser recess with abrush. 6. Put back the dispenser in the re-cess. DRAIN PUMP Regularly examin...
Page 23 - To clean the drain pump:; Open the drain pump door.
To clean the drain pump: 1. Open the drain pump door. 2. Put a container below the recess ofthe drain pump to collect the waterthat flows out. 3. Press the two levers and pull for-ward the drainage duct to let thewater flow out. 4. When the container is full of water,put the drainage duct back again...
Page 24 - To clean the water inlet filters:
2 1 8. Clean the filter under the water tapand put it back in the pump intothe special guides. 9. Make sure that you tighten correct-ly the filter to prevent leakages. 11. Close the drain pump door. THE INLET HOSE FILTER ANDTHE VALVE FILTER It could be necessary to clean the filterswhen:• The applia...
Page 25 - Remove the water inlet hose
45° 35° 6. Install again the inlet hose. Makesure that the couplings are tight toprevent leakages. 7. Open the water tap. EMERGENCY DRAIN Because of a malfunction, the appliancecannot drain the water.If this occurs, do steps (1) through (6) of'To clean the drain pump'.If necessary, clean the pump.Pu...
Page 26 - TROUBLESHOOTING
TROUBLESHOOTING The start of the appliance does not oc-cur or it stops during operation.First try to find a solution to the prob-lem (refer to the table). If not, contactthe service centre. With some problems, the acousticsignals operate and the displayshows an alarm code: • - The appliance does not...
Page 29 - INSTALLATION; UNPACKING; Remove the cardboard top.
INSTALLATION UNPACKING 1. Use the gloves. Remove the exter-nal film. If necessary, use a cutter. 2. Remove the cardboard top. 3. Remove the polystyrene packagingmaterials. 4. Remove the internal film. 5. Open the door and remove all theitems from the drum. ENGLISH 29
Page 30 - Pull out the plastic spacers.
6. Put the front piece on the floor be-hind the appliance. Carefully putdown the appliance with the rearside on it. Make sure not to dam-age the hoses. 1 2 7. Remove the polystyrene protectionfrom the bottom. 8. Pull up the appliance in vertical po-sition. 9. Remove the power supply cableand the dra...
Page 31 - POSITIONING AND LEVELLING
12. Replace the plastic spacers withthe plastic caps. You can find thesecaps in the user manual bag. – We recommend that you keep the packaging and thetransit bolts for when youmove the appliance. – If the appliance is delivered in the winter months when thereare minus temperatures. Storeit at room ...
Page 32 - • The appliance must be level and sta-; THE INLET HOSE; • Connect the hose to the appliance.
• The appliance must be level and sta- ble. CAUTION! Do not put cardboard, wood orequivalent materials below theappliance feet to adjust the lev-el. THE INLET HOSE 35 O 35 O 35 O 45 O 45 O 45 O • Connect the hose to the appliance. Turn the inlet hose only left or right.Loose the ring nut to set it i...
Page 33 - WATER DRAINAGE; With the plastic hose guide.
Water-stop device A The inlet hose has a water stop device.This device prevents water leaks in thehose because of its natural ageing. Thered sector in the window «A» shows thisfault .If this occur, close the water tap andcontact the service centre to replacethe hose. WATER DRAINAGE There are differe...
Page 34 - Without the plastic hose guide.; • To a sink spigot.
Without the plastic hose guide. • To a sink spigot. Refer to the illustration. Put the drainhose in the spigot and tighten it witha clip. Make sure that the drain hosemakes a loop to prevent that remain-ing particles go in the appliance fromthe sink. • Directly to a built-in drain pipe in the room w...
