Page 2 - CUSTOMER CARE AND SERVICE; SAFETY INFORMATION; Before the installation and use of the appliance,
CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................5 3. PRODUCT DESCRIPTION......................................
Page 5 - SAFETY INSTRUCTIONS; Installation
2. SAFETY INSTRUCTIONS This appliance is suitable for thefollowing markets: GB IE 2.1 Installation WARNING! Only a qualified person must install this appliance. WARNING! Risk of injury or damage to the appliance. • Remove all the packaging. • Do not install or use a damaged appliance. • Follow the i...
Page 7 - PRODUCT DESCRIPTION; Cooking surface layout
• Do not install a flame diffuser on the burner. • The use of a gas cooking appliance results in the production of heat and moisture. Provide good ventilation in the room where the appliance is installed. • Prolonged intensive use of the appliance may call for additional ventilation, for example ope...
Page 8 - Control knob; DAILY USE; Burner overview
3.2 Control knob Symbol Description no gas supply / off posi-tion Symbol Description ignition position / maxi-mum gas supply minimum gas supply 4. DAILY USE WARNING! Refer to Safety chapters. 4.1 Burner overview A B D C C D A B A. Burner cap B. Burner crown C. Ignition candle D. Thermocouple 4.2 Ign...
Page 9 - HINTS AND TIPS; Cookware
CAUTION! In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, turn the control knob counter- clockwise to maximum gas supply position and push it down. Keep the control knob pushed for equal or less than 10 seconds to let t...
Page 10 - Diameters of cookware; CARE AND CLEANING; General information
CAUTION! Make sure that pot handles are not above the front edge of the cooktop. CAUTION! Make sure that the pots are placed centrally on the burner in order to get maximum stability and to get lower gas consumption. CAUTION! Liquids spilt during cooking can cause the glass to break. 5.2 Diameters o...
Page 11 - Cleaning the spark plug
6.3 Removing pan supports To keep the pan supports in the correct position, they are put on metal pins installed in the rear side of the hob. For easier cleaning, pan supports can be removed from the hob. Lift up the pan supports keeping them in horizontal position and with the right order as shown ...
Page 12 - TROUBLESHOOTING; If you cannot find a
7. TROUBLESHOOTING WARNING! Refer to Safety chapters. 7.1 What to do if... Problem Possible cause Remedy There is no spark when youtry to activate the spark gen-erator. The hob is not connected toan electrical supply or it isconnected incorrectly. Check if the hob is correctlyconnected to the electr...
Page 13 - INSTALLATION; Before the installation
7.3 Labels supplied with the accessories bag Stick the adhesive labels as indicated below: MOD. PROD.NO. SER.NO DATA MOD. PROD.NO. SER.NO DATA MOD. PROD.NO. SER.NO. 03 IT MADE IN ITALY TYPE IP20 0049 A B C A. Stick it on Guarantee Card and send this part (if applicable). B. Stick it on Guarantee Car...
Page 14 - Gas Connection
However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m³ and 11 m³.If there are other fuel burning appliances in the same room, B.S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements...
Page 16 - Replacement of the
2. The supply system is equipped with an efficient earth connection in compliance with the current standards and regulations 3. The outlet or omnipolar switch used for connection is easily accessible with the appliance installed. The appliance is supplied with a 3 core flexible power cable with a 3 ...
Page 17 - Assembly
8.8 Assembly 1. 2. 3. min. 55 mm min. 650 mm 560 mm min. 150 mm 30 mm 480 mm min. 600 mm 4. 50 mm 400 mm If a furniture unit is installed at a distance of 400 mm above the hob, there must be a minimum safety distance of 50 mm to the left or right from the edge of the hob. 5. 6. 7. B A A) supplied se...
Page 18 - Possibilities for insertion; TECHNICAL DATA; Hob dimensions; Bypass diameters; Other technical data
CAUTION! Install the appliance only on a worktop with flat surface. 8.9 Possibilities for insertion The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. Kitchen unit with door or drawer min 6 mm min 30 mm 60 mm b a ...
Page 19 - Gas burners for NATURAL GAS G20 20 mbar; ENERGY EFFICIENCY; Product information according to EU 66/2014
Appliance category: II2H3+ Gas connection: R 1/2" Appliance class: 3 9.4 Gas burners for NATURAL GAS G20 20 mbar BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK Multi Crown 3,9 1,4 146 Semi-rapid 1,9 0,45 96 Auxiliary 1,0 0,33 70 9.5 Gas burners for LPG G30/G31 28-30/37 mbar BURNER NORMALP...
Page 20 - Energy saving; ENVIRONMENTAL CONCERNS
10.2 Energy saving • Before use, make sure that the burners and pan supports are assembled correctly. • Use cookware with diameters applicable to the size of burners. • Center the pot on the burner. • When you heat up water, use only the amount you need. • If it is possible, always put the lids on t...