Page 2 - CUSTOMER CARE AND SERVICE; SAFETY INFORMATION; Before the installation and use of the appliance,
CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. PRODUCT DESCRIPTION......................................
Page 4 - SAFETY INSTRUCTIONS; Installation
• CAUTION: The cooking process has to be supervised. A short term cooking process has to be supervised continuously. • WARNING: Danger of fire: Do not store items on the cooking surfaces. • Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can...
Page 7 - PRODUCT DESCRIPTION; Cooking surface layout; DAILY USE
• Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use any abrasive products, abrasive cleaning pads, solvents or metal objects. • Do not clean the burners in the dishwasher. 2.6 Disposal WARNING! Risk of injury or suffocation. • Contact your municipal authority for i...
Page 9 - HINTS AND TIPS; Cookware; CARE AND CLEANING; General information; Pan supports
5. HINTS AND TIPS WARNING! Refer to Safety chapters. 5.1 Cookware CAUTION! Do not use cast iron pans, potstones, earthenware, grill or toaster plates. The stainless steel can become tarnished if it is too much heated. WARNING! Do not put the same pan on two burners. WARNING! Do not put unstable or d...
Page 10 - Cleaning the hob; Cleaning the spark plug; TROUBLESHOOTING
Be very careful when you replace the pan supports to prevent the hob top from damage. 2. The enamel coating occasionally can have rough edges, so be careful when you wash the pan supports by hand and dry them. If necessary, remove stubborn stains with a paste cleaner. 3. After you clean the pan supp...
Page 11 - If you cannot find a
7.1 What to do if... Problem Possible cause Remedy There is no spark when youtry to activate the spark gen-erator. The hob is not connected toan electrical supply or it isconnected incorrectly. Check if the hob is correctlyconnected to the electricalsupply. The fuse is blown. Make sure that the fuse...
Page 12 - INSTALLATION; Before the installation
7.3 Labels supplied with the accessories bag Stick the adhesive labels as indicated below: MOD. PROD.NO. SER.NO DATA MOD. PROD.NO. SER.NO DATA MOD. PROD.NO. SER.NO. 03 IT MADE IN ITALY TYPE IP20 0049 A B C A. Stick it on Guarantee Card and send this part (if applicable). B. Stick it on Guarantee Car...
Page 13 - Gas Connection
However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m³ and 11 m³.If there are other fuel burning appliances in the same room, B.S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements...
Page 15 - Replacement of the
2. The supply system is equipped with an efficient earth connection in compliance with the current standards and regulations 3. The outlet or omnipolar switch used for connection is easily accessible with the appliance installed. The appliance is supplied with a 3 core flexible power cable with a 3 ...
Page 16 - Assembly
8.8 Assembly 1. 2. 3. min. 55 mm min. 650 mm 560 mm min. 100 mm 30 mm 480 mm min. 600 mm 4. 50 mm 400 mm If a furniture unit is installed at a distance of 400 mm above the hob, there must be a minimum safety distance of 50 mm to the left or right from the edge of the hob. 5. 6. 7. 8. 9. www.aeg.com ...
Page 17 - Possibilities for insertion; TECHNICAL DATA; Hob dimensions; Bypass diameters
A B A) supplied seal B) supplied brackets 10. 11. CAUTION! Install the appliance only on a worktop with flat surface. 8.9 Possibilities for insertion The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. Kitchen unit...
Page 18 - ENERGY EFFICIENCY; Product information according to EU 66/2014
BURNER Ø BYPASS 1/100 mm Auxiliary 32 9.3 Other technical data TOTAL POWER: Gas original: G20 (2H) 20 mbar = 7,5 kW Gas replacement: G30 (3+) 28-30 mbar = 542 g/hG31 (3+) 37 mbar = 532 g/h Electric supply: 220-240 V ~ 50/60 Hz3 core flexible cable with non rewireable plug fitted with a 3 ampcartridg...
Page 19 - Energy saving; ENVIRONMENTAL CONCERNS
Energy efficiency per gas burner(EE gas burner) Left rear - Semi-rapid 55.0% Right rear - Semi-rapid 55.0% Left front - Rapid 57.5% Right front - Auxiliary not applicable Energy efficiency for the gas hob(EE gas hob) 55.8% EN 30-2-1: Domestic cooking appliances burning gas - Part 2-1 : Rational use ...