AEG HC412001GB- User Manual

3.2 Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition).For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I.S...

Electrical Requirements Permanent electrical installation must agree with the latest I.E.E. Regulations and local Electricity Board regulations. For your own safety the installation must be done by a qualified electrician (e.g. your local Electricity Board, or a contractor who is on the roll of the ...

3.8 Assembly 1. 2. 3. 40-50 mm 55 mm 30 mm min. 650 mm 490 mm 340 mm min. 100 mm 4. 5. 6. B A A) supplied seal B) assembled bracket 7. CAUTION! Install the appliance only on a worktop with flat surface. 3.9 Installation of more than one hob Supplied accessories: connection bar, sealing stripe. Use o...

The worktop cutout Distancefrom thewall minimum 50 mm Depth 490 mm Width sum of all widths of hobs thatyou install minus 20 mm Example: 580 mm 5 2 0 mm 4 9 0 mm 360 mm + - = 20 mm 920 mm Assembly 1. Calculate correct cutout dimensions. 2. Prepare cutout in the worktop. 3. One by one place the hobs o...

4. PRODUCT DESCRIPTION 4.1 Cooking surface layout 1 2 3 1 Rapid burner 2 Auxiliary burner 3 Control knobs 4.2 Control knob Symbol Description no gas supply / off posi-tion Symbol Description ignition position / maxi-mum gas supply minimum gas supply 5. DAILY USE WARNING! Refer to Safety chapters. 5....

If after some tries the burner does not light, check if the crown and its cap are in correct positions. WARNING! Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burne...

6.2 Diameters of cookware Use cookware with diameters applicable to the size of burners. Burner Diameter ofcookware (mm) Rapid 180 - 260 Burner Diameter ofcookware (mm) Auxiliary 80 - 180 7. CARE AND CLEANING WARNING! Refer to Safety chapters. 7.1 General information • Clean the hob after each use. ...

The shape of pan supports and the amount of burners can be different in other models of the appliance. 7.4 Cleaning the hob • Remove immediately: melted plastic, plastic foil, sugar and food with sugar, otherwise, the dirt can cause damage to the hob. Take care to avoid burns. • Remove when the hob ...

Problem Possible cause Remedy The fuse is blown. Make sure that the fuse isthe cause of the malfunction.If the fuse is blown againand again, contact a quali-fied electrician. Burner cap and crown areplaced incorrectly. Place the burner cap andcrown correctly. The flame extinguishes im-mediately afte...

8.3 Labels supplied with the accessories bag Stick the adhesive labels as indicated below: MOD. PROD.NO. SER.NO DATA MOD. PROD.NO. SER.NO DATA MOD. PROD.NO. SER.NO. 03 IT MADE IN ITALY TYPE IP20 0049 A B C A. Stick it on Guarantee Card and send this part (if applicable). B. Stick it on Guarantee Car...

9.3 Other technical data TOTAL POW-ER: Gas original: G20 (2H) 20 mbar 3,95 kW Gas replace-ment: G30 (3+) 28-30 mbar 276 g/h G31 (3+) 37 mbar 271 g/h Electric supply: 220-240 V ~ 50/60 Hz Appliance cate-gory: II2H3+ Gas connec-tion: R 1/2" Applianceclass: 3 9.4 Gas burners for NATURAL GAS G20 20 ...

EN 30-2-1: Domestic cooking appliances burning gas - Part 2-1 : Rational use of energy - General 10.2 Energy saving • Before use, make sure that the burners and pan supports are assembled correctly. • Use cookware with diameters applicable to the size of burners. • Center the pot on the burner. • Wh...