AEG FSS63400P- User Manual

When AirDry is activated during the drying phase, the projection on the floor may not be completely visible. To check the remaining time of the running programme, look at the control panel display. 4. CONTROL PANEL 1 2 3 4 5 6 7 8 9 1 On/off button 2 Display 3 Delay button 4 Program button 5 ExtraHy...

Programme Degree of soilType of load Programme phases Options P2 2) • All• Crockery, cut- lery, pots andpans • Prewash• Wash from 45 °C to 70 °C • Rinses• Dry • ExtraHygiene• XtraDry P3 3) • Mixed soil• Crockery, cut- lery, pots andpans • Prewash• Wash 50 °C and 65 °C• Rinses• Dry • TimeSaver• XtraD...

Programme 1) Water (l) Energy (kWh) Duration (min) P2 6 - 12 0.5 - 1.2 40 - 150 P3 11 - 13 1.0 - 1.2 130 - 150 P4 11 - 13 1.0 - 1.2 130 - 150 P6 8 0.6 - 0.8 30 P7 9 - 11 0.9 - 1.1 220 - 230 P5 10 - 12 0.8 - 0.9 60 - 80 1) The pressure and the temperature of the water, the variations of the mains sup...

indicators , , , and flash and the display is blank. 6.2 The water softener The water softener removes minerals from the water supply, which would have a detrimental effect on the washing results and on the appliance.The higher the content of these minerals, the harder your water is. Water hardness ...

During the drying phase, the door opens automatically and remains ajar. CAUTION! Do not try to close the appliance door within 2 minutes after automatic opening. This can cause damage to the appliance. AirDry is automatically activated with allprogrammes excluding (if applicable).To improve the dryi...

How to activate XtraDry Press . The related indicator comes on. 7.3 TimeSaver This option increases the pressure and the temperature of the water. The washing and the drying phases are shorter.The total programme duration decreases by approximately 50%. The washing results are the same as with the n...

8.2 How to fill the rinse aid dispenser A B D C M A X 1 2 3 4 + - A B D C CAUTION! Only use rinse aid specifically designed for dishwashers. 1. Press the release button ( D ) to open the lid ( C ). 2. Pour the rinse aid in the dispenser ( A ) until the liquid reaches the fill level 'max'. 3. Remove ...

Cancelling the programme Press and hold RESET until the appliance is in programme selection mode. Make sure that there is detergent in the detergent dispenser before you start a new programme. End of the programme When the programme is completed the display shows 0:00 and the end indicator is on. Al...

10.4 Loading the baskets • Only use the appliance to wash items that are dishwasher-safe. • Do not put in the appliance items made of wood, horn, aluminium, pewter and copper. • Do not put in the appliance items that can absorb water (sponges, household cloths). • Remove remaining food from the item...

• If you regularly use short duration programmes, these can leave deposits of grease and limescale inside the appliance. To prevent this, we recommend to run long duration programmes at least 2 times per month. • To maintain the performance of your appliance at its best, we recommend to use monthly ...

Problem and alarm code Possible cause and solution The appliance stops andstarts more times during op-eration. • It is normal. It provides optimal cleaning results and en- ergy savings. The program lasts too long. • Select the TimeSaver option to shorten the program time. • If the delayed start opti...

Problem Possible cause and solution Limescale deposits on the ta-bleware, on the tub and onthe inside of the door. • The level of salt is low, check the refill indicator.• The cap of the salt container is loose.• Your tap water is hard. Refer to "The water softener" . • Even using multi-func...