Page 3 - Contents
3 Contents Safety instructions 4 Disposing of packaging and old machine 6 Disposing of the packaging 6 Disposing of your old machine 6 Economical and ecological dishwashing 7 Description of the appliance 8 The inside of the appliance 8 Control panel 9 Before using your dishwasher for the first time ...
Page 4 - Safety instructions; Using your dishwasher for its intended purpose
4 Safety instructions The safety of AEG electrical appliances conforms to accepted rules oftechnology and the Appliance Safety Act. We as manufacturers, however, seeourselves as being obliged to familiarise you with the following safetyinstructions. Using your dishwasher for its intended purpose ● O...
Page 6 - Disposing of packaging and old machine; Disposing of the packaging; Disposing of your old machine
Marking of plastic parts for graded recycling: all plastic parts in yourmachine are marked with internationally standardised abbreviations (e.g.<PS> for polystyrene). When your machine is disposed of, this enables plasticwaste to be sorted into individual types for environmentally consciousrec...
Page 7 - Economical and ecological dishwashing
7 Economical and ecological dishwashing ● Only connect the dishwasher to the hot water supply if your hot water is not electrically heated. ● Ensure that the water softener is correctly adjusted. ● Do not pre-rinse under running water. ● Select the wash programme to suit the nature and degree of the...
Page 8 - Description of the appliance; The inside of the appliance
8 Description of the appliance 1 2 3 4 5 6 7 8 9 10 11 12 13 14 IN68 The inside of the appliance 1. Water hardness adjustment 2. Levelling spacers 3. Upper basket stop 4. Salt container 5. Large filter 6. Detergent dispenser 7. Control panel 8. Rating plate 9. Rinse aid dispenser 10. Central filter ...
Page 10 - Before using your dishwasher for the first time; Setting the water hardness range
10 Before using your dishwasher for the first time 1. Ensure that the electrical and water connections comply with the installation instructions. 2. Remove all packaging from inside the appliance. 3. Set the water softener. 4. Pour 1 litre of water inside the salt container and then fill with salt. ...
Page 11 - Filling with special salt
11 With a screwdriver turn the selector on theupper front corner of the machine untilthe level required corresponds with themarker. 2 AA05 1 3 5 4 2 If your water is level 0 it is already soft and therefore there is noneed to use salt. In this case adjust the water softener on level 1without using s...
Page 12 - Pour 1 litre of water inside; Salt refill indicator; green float
12 To fill: 1. To fill with salt, unscrew the cap of the salt container. 2. Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time). 3. Using the funnel provided, pour in the salt until the container is full.Do not worry if water overflows from...
Page 13 - Filling up the rinse-aid
13 The rinse-aid The rinse-aid ensures brilliant crockery and also helps it to dry. It isautomatically dosed in during the hot rinsing cycle. The storagecompartment built in to the in side of the door can hold about 110 ml ofrinse-aid, which will be sufficient for between 16 and 40 dishwashingprogra...
Page 14 - Adjusting the dose
14 Adjusting the dose The correct dosage of the rinse-aidshould be regulated on the basis ofthe shine and drying results. For this purpose, set the quantity ofliquid by means of the six-positionselector (C) located on the inside ofthe filler opening (minimum quantityis position 1, maximum quantity i...
Page 15 - Loading cutlery and dishes; Do not load very small items which can fall through the baskets.
15 Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. For washing in the dishwasher the following cutlery/dishes are not suitable: ● Cutlery with wooden, horn, china or mother of pearl handles. ● Plastic items that are not h...
Page 17 - Cutlery basket
17 Cutlery should be placed in the removable cutlery basket with the handlesfacing downwards. If the handles protrude from the bottom of the basket,obstructing the lower spray arm, load the cutlery with the handles facingdownwards. Mix spoons with other cutlery to prevent the from sticking together....
Page 18 - Use of detergent
18 Use of detergent Attention!Only use detergents specifically designed for use in dishwashers. If using powder detergents proceedas follows: 1. Open the dispenser lid by pulling the catch (D). 2. Add the detergent. As all detergents are not the same, please pay attention to the dosage instructions ...
Page 19 - Compact detergents with enzymes
19 Remember that insufficient quantities of detergent will producepoor washing results whereas an excessive amount of detergentdoes not improve washing results and is also wasteful. Compact detergents with enzymes In these compact powders the environmentally unfriendly components havebeen replaced b...
Page 20 - Washing programmes; Rinse
20 * This is a special programme for quick washing a full load of lightly soiled dishes, glasses and crockery (except pots) so that you may re-use them promptly. Washing programmes Programmes Normal 65° * Quick 65° Rinse and Hold Type of soilType of load Normal soil.Crockery and cutlery Light soil.C...
Page 22 - Operating instructions; Check the filters
22 Operating instructions 1. Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning"). 2. Check that there is rinse aid and salt 3. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it...
Page 23 - Start the programme; At the end of the washing programme
23 7. Start the programme Turn the water tap on. Depress the On/Off push button. The On/Off indicator light will come on and the machine will start. 8. At the end of the washing programme At the end of the washing programme the machine stops automatically. The On/Off indicator light remains on until...
Page 24 - Maintenance and cleaning; Internal and external cleaning; Cleaning the central filter
24 Maintenance and cleaning Internal and external cleaning Do not under any circumstances use furniture care products oraggressive cleaners. If necessary, clean the controls only with a soft cloth and pure warm water. The spray arms do not need cleaning. Occasionally check the internal containers, d...
Page 25 - Cleaning the large filter; To remove the large filter
25 Cleaning the large filter (every month) If necessary clean the large filter (B) on both sides under running water,using a brush. To remove the large filter 1. Remove the spray arm by pulling it upwards on one side. 2. Turn the column (C) anticlockwise by 90° and then slide out the filter. 3. Once...
Page 28 - Customer service
28 Customer service In the section "What to do, when...", we have listed the most important faultswhich you can rectify yourself. Should you still wish to call our ServiceCentre for any of the specified faults or because the appliance is beingwrongly operated, the service engineer's visit ca...
Page 29 - Technical data; Technical specifications
29 Technical data This appliance complies with the following E.E.C. Directives:- 73/23/CEE of 19/02/73 (Low Voltage Directive) and subsequentmodifications;- 89/336/CEE of 03/05/89 (Electromagnetic CompatibilityDirective) and subsequent modifications. Technical specifications Dimensions Electrical co...
Page 30 - Hints for test centres
30 Hints for test centres Before starting any test it is necessary to fill completely with salt the saltcontainer and with rinse aid the rinse aid dispenser. Test standard Load Rinse aid selector Detergent dosage Reference programme EN 50242 position 5 - 25 g in the dispenser- 5 g on the dispenser l...
Page 31 - Levelling; Installation
31 Adjusting the worktop You can move the worktop forward orbackward by 25 mm in order to align themachine with other kitchen units.Simply unscrew the two rear retainingscrews, move the top to the requiredposition and then retighten the screws. Fitting under a counter (kitchen worktop or sink) By re...
Page 32 - Connection instructions; Water supply connections
32 Connection instructions Any electrical work required to install this appliance should be carriedout by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carriedout by a qualified plumber or competent person. Remove all packaging before pos...
Page 33 - Water outlet connection
33 Water outlet connection The end of the drain hose can be connected as follows: 1. To the sink outlet siphon, securing it if necessary with a clip. 2. Hooked over the edge of the sink using the special curved plastic guide provided. 3. To a wall outlet provided with vent-hole, minimum internal dia...
