Page 2 - CUSTOMER CARE AND SERVICE
CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION...............................
Page 4 - SAFETY INSTRUCTIONS; Installation
• Put knives and cutlery with sharp points in the cutlery basket with the points down or in a horizontal position. • Do not keep the appliance door open without supervision to prevent to fall on it. • Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. •...
Page 6 - PRODUCT DESCRIPTION
3. PRODUCT DESCRIPTION 12 6 5 8 9 3 4 2 1 10 7 11 1 Work-top 2 Top spray arm 3 Upper spray arm 4 Lower spray arm 5 Filters 6 Rating plate 7 Air vent 8 Rinse aid dispenser 9 Detergent dispenser 10 Cutlery basket 11 Lower basket 12 Upper basket www.aeg.com 6
Page 7 - CONTROL PANEL; Indicators
4. CONTROL PANEL 1 2 4 5 6 8 3 7 1 On/off button 2 Program touchpad 3 Programme indicators 4 Display 5 Delay touchpad 6 Option touchpad 7 Indicators 8 Start touchpad 4.1 Indicators Indicator Description Washing phase. It comes on when the washing phase and the rinsing pha-ses operate. Rinsing phase....
Page 8 - PROGRAMMES
5. PROGRAMMES Programme Degree of soilType of load Programme phases Options 1) • Normal soil• Crockery and cut- lery • Prewash• Wash 50 °C• Rinses• Dry • ExtraHygiene• TimeSaver• XtraDry 2) • All• Crockery, cutlery, pots and pans • Prewash• Wash from 45 °C to 70 °C • Rinses• Dry • ExtraHygiene• Xtra...
Page 9 - Consumption values; Information for test
Programme Degree of soilType of load Programme phases Options 6) • Normal soil• Crockery and cut- lery • Prewash• Wash 50 °C• Rinses• Dry • XtraDry 1) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal soil. (This is the standard ...
Page 10 - SETTINGS
6. SETTINGS 6.1 Programme selection mode and user mode When the appliance is in programme selection mode it is possible to set a programme and to enter the user mode. In user mode, the following settings can be changed: • The activation or deactivation of the rinse aid empty notification. • The leve...
Page 11 - OPTIONS; BEFORE FIRST USE
• The indicator continues to flash. • The display shows the current setting: = the rinse aid dispenser is activated (factory setting). 3. Press Program to change the setting. = the rinse aid dispenser is deactivated. 4. Press the on/off button to confirm the setting. 7. OPTIONS Desired options must ...
Page 12 - DAILY USE; Using the detergent
detergent and do not load the baskets. 8.1 How to fill the rinse aid dispenser A B C CAUTION! Only use rinse aid specifically designed for dishwashers. 1. Open the lid ( C ). 2. Fill the dispenser ( B ) until the rinse aid reaches the marking ''MAX''. 3. Remove the spilled rinse aid with an absorben...
Page 14 - HINTS AND TIPS
10. HINTS AND TIPS 10.1 General The following hints will ensure optimal cleaning and drying results in daily use and also help to protect the environment.• Remove larger residues of food from the dishes into the waste bin. • Do not pre-rinse dishes by hand. When needed, use the prewash programme (if...
Page 15 - CARE AND CLEANING; Cleaning the filters
4. First remove items from the lower basket then the upper basket. At the end of the program water can still remain on the sides and on the door of the appliance. 11. CARE AND CLEANING WARNING! Before maintenance, deactivate the appliance and disconnect the mains plug from the main socket. Dirty fil...
Page 17 - Internal cleaning; TROUBLESHOOTING
• Do not use abrasive products, abrasive cleaning pads or solvents. 11.5 Internal cleaning • Carefully clean the appliance, including the rubber gasket of the door, with a soft damp cloth. • If you regularly use short duration programmes, these can leave deposits of grease and limescale inside the a...
Page 18 - The washing and drying results are not satisfactory
Problem and alarm code Possible solution The anti-flood device is on.The display shows . • Close the water tap and contact an Authorised Service Centre. The appliance stops andstarts more times during op-eration. • It is normal. It provides optimal cleaning results and en- ergy savings. The program ...
Page 20 - TECHNICAL INFORMATION; INSTALLATION; Fitting under a counter
Problem Possible cause and solution Limescale deposits on the ta-bleware, on the tub and onthe inside of the door. • Refer to "The water softener" . Dull, discoloured or chippedtableware. • Make sure that only dishwasher-safe items are washed in the appliance. • Load and unload the basket ca...
Page 22 - WARRANTY
must be purchased from Electrolux Spare Parts. The extension length must not exceed 2 metres.The drain hose must be free of obstructions.Remove the sink plug when the appliance drains the water to prevent that the water goes back into the appliance.The appliance has a security feature to prevent dir...
Page 25 - ENVIRONMENT CONCERNS
FOR SPARE PARTS or to find the address of your nearest state spare parts centre in New Zealand FREE CALL 0800 10 66 20OR EMAIL [email protected] (New Zealand only) 16. ENVIRONMENT CONCERNS Please recycle all materials marked withthe symbol . Dispose of all packaging materials appropriate...
