AEG F88708W0P- User Manual

3 Upper spray arm 4 Lower spray arm 5 Filters 6 Rating plate 7 Salt container 8 Air vent 9 Rinse aid dispenser 10 Detergent dispenser 11 Lower basket 12 Upper basket 13 Cutlery drawer 4. CONTROL PANEL 1 2 4 5 6 8 3 7 1 On/off button 2 Program button 3 Programme indicators 4 Display 5 Delay button 6 ...

Indicator Description XtraDry indicator. Rinse aid indicator. It is always off while the programme operates. Salt indicator. It is always off while the programme operates. Delay indicator. ExtraHygiene indicator. 5. PROGRAMMES Programme Degree of soilType of load Programme phases Options 1) • Normal...

Programme Degree of soilType of load Programme phases Options 6) • Normal soil• Crockery and cut- lery • Prewash• Wash 50 °C• Rinses• Dry • XtraDry 1) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal soil. (This is the standard ...

6. SETTINGS 6.1 Programme selection mode and user mode When the appliance is in programme selection mode it is possible to set a programme and to enter the user mode. In user mode, the following settings can be changed: • The level of the water softener according to the water hardness. • The activat...

• The indicators , and go off. • The indicator continues to flash. • The display shows the current setting: = the rinse aid dispenser is activated (factory setting). 3. Press Start to change the setting. = the rinse aid dispenser is deactivated. 4. Press the on/off button to confirm the setting. 6.5...

not come on or it flashes quickly for a few seconds and then goes off. The display shows the updated programme duration. 7.3 ExtraHygiene With this option you have better hygiene results. During the last rinsing phase, the temperature stays at 70 °C for at least 10 minutes. How to activate ExtraHygi...

8.1 The salt container CAUTION! Only use salt specifically designed for dishwashers. The salt is used to recharge the resin in the water softener and to assure good washing results in the daily use. How to fill the salt container 1. Turn the cap of the salt container counterclockwise and remove it. ...

Press simultaneously Delay and Option until the appliance is in programme selection mode. Cancelling the programme Press and hold simultaneously Delay and Option until the appliance is in programme selection mode. Make sure that there is detergent in the detergent dispenser before you start a new pr...

2. Make sure that the salt and rinse aid containers are full. 3. Start the shortest programme with a rinsing phase. Do not add detergent and do not load the baskets. 4. When the programme is completed, adjust the water softener according to the water hardness in your area. 5. Adjust the released qua...

11.2 Cleaning the upper spray arm We recommend to clean regularly the upper spray arm to avoid soil to clog the holes.Clogged holes can cause unsatisfactory washing results. 1. Pull out the upper basket. 2. To disengage the spray arm from the basket, press the spray arm upwards in the direction indi...

Problem and alarm code Possible cause and solution Small leak from the appli-ance door. • The appliance is not levelled. Loosen or tighten the ad- justable feet (if applicable). • The appliance door is not centred on the tub. Adjust the rear foot (if applicable). The appliance door is diffi-cult to ...

Problem Possible cause and solution Dull, discoloured or chippedtableware. • Make sure that only dishwasher-safe items are washed in the appliance. • Load and unload the basket carefully. Refer to basket loading leaflet. • Place delicate items in the upper basket. Refer to "Before first use"...