Page 2 - CUSTOMER CARE AND SERVICE
CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION...............................
Page 4 - SAFETY INSTRUCTIONS; Installation
• Put knives and cutlery with sharp points in the cutlery basket with the points down or in a horizontal position. • Do not keep the appliance door open without supervision to prevent to fall on it. • Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. •...
Page 5 - PRODUCT DESCRIPTION
WARNING! Dangerous voltage. • If the water inlet hose is damaged, immediately disconnect the mains plug from the mains socket. Contact the Authorised Service Centre to replace the water inlet hose. 2.4 Use • Do not sit or stand on the open door. • Dishwasher detergents are dangerous. Obey the safety...
Page 6 - CONTROL PANEL; Indicators
5 Filters 6 Rating plate 7 Salt container 8 Air vent 9 Rinse aid dispenser 10 Detergent dispenser 11 Cutlery basket 12 Lower basket 13 Upper basket 4. CONTROL PANEL 1 2 4 5 6 8 3 7 1 On/off button 2 Program button 3 Programme indicators 4 Display 5 Delay button 6 Option button 7 Indicators 8 Start b...
Page 7 - PROGRAMMES
Indicator Description Rinse aid indicator. It is always off while the programme operates. TimeSaver indicator. Delay indicator. ExtraHygiene indicator. 5. PROGRAMMES Programme Degree of soilType of load Programme phases Options 1) • Normal soil• Crockery and cut- lery • Prewash• Wash 50 °C• Rinses• ...
Page 8 - Consumption values; Information for test; SETTINGS; Programme selection
Programme Degree of soilType of load Programme phases Options 5) • Normal soil• Crockery and cut- lery • Prewash• Wash 50 °C• Rinses• Dry • Multitab 1) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal soil. (This is the standard...
Page 9 - How to set the water softener
• The deactivation of the rinse aid dispenser when you want to use the Multitab option without rinse aid. • The level of rinse aid according to the required dosage. These settings will be saved until you change them again. How to set the programme selection mode The appliance is in programme selecti...
Page 13 - DAILY USE
9. DAILY USE 1. Open the water tap. 2. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode. • If the salt indicator is on, fill the salt container. • If the rinse aid indicator is on, fill the rinse aid dispenser. 3. Load the baskets. 4. Add...
Page 14 - HINTS AND TIPS
the running phase comes on. The delay indicator goes off. Opening the door while the appliance operates If you open the door while a programme is running, the appliance stops. When you close the door, the appliance continues from the point of interruption. Cancelling the delay start while the countd...
Page 15 - CARE AND CLEANING
drying results with the use of multi- tablets. • Detergent tablets do not fully dissolve with short programmes. To prevent detergent residues on the tableware, we recommend that you use the tablets with long programmes. • Do not use more than the correct quantity of detergent. Refer to the instructi...
Page 16 - Cleaning the filters
11.1 Cleaning the filters The filter system is made of 3 parts. C B A 1. Turn the filter ( B ) counterclockwise and remove it. 2. Remove the filter ( C ) out of filter ( B ). 3. Remove the flat filter ( A ). 4. Wash the filters. 5. Make sure that there are no residues of food or soil in or around th...
Page 17 - TROUBLESHOOTING
11.2 Cleaning the upper spray arm We recommend to clean regularly the upper spray arm to avoid soil to clog the holes.Clogged holes can cause unsatisfactory washing results. 1. Pull out the upper basket. 2. To disengage the spray arm from the basket, press the spray arm upwards in the direction indi...
Page 19 - The washing and drying results are not satisfactory
Problem and alarm code Possible cause and solution Small leak from the appli-ance door. • The appliance is not level. Loosen or tighten the adjust- able feet (if applicable). • The appliance door is not centred on the tub. Adjust the rear foot (if applicable). The appliance door is diffi-cult to clo...
Page 20 - TECHNICAL INFORMATION
Problem Possible cause and solution The dishes are wet. • The programme does not have a drying phase or has a drying phase with low temperature. • The rinse aid dispenser is empty.• The quality of the rinse aid can be the cause.• The quality of the multi-tablets can be the cause. Try a different bra...
Page 21 - ENVIRONMENT CONCERNS
Electrical connection 1) Voltage (V) 220 - 240 Frequency (Hz) 50 / 60 Water supply pressure bar (minimum and maximum) 0.5 - 8 MPa (minimum and maximum) 0.05 - 0.8 Water supply Cold water or hot water 2) max 60 °C Capacity Place settings 13 Power consumption Left-on mode (W) 0.99 Power consumption Of...
