AEG F34310VI0- User Manual

Page 2 - reading to get the very best from it.; CUSTOMER CARE AND SERVICE; Always use original spare parts.

CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION...............................

Page 4 - SAFETY INSTRUCTIONS; Installation

• Put knives and cutlery with sharp points in the cutlery basket with the points down or in a horizontal position. • Do not keep the appliance door open without supervision to prevent to fall on it. • Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. •...

Page 7 - Indicators; PROGRAMMES; Information for test

4.1 Indicators Indicator Description Running programme indicator. It comes on when the programme startsand goes off when the programme is completed. End indicator. Salt indicator. It is always off while the programme operates. Rinse aid indicator. It is always off while the programme operates. 5. PR...

Page 8 - SETTINGS; Programme selection; How to set the programme

6. SETTINGS 6.1 Programme selection mode and user mode When the appliance is in programme selection mode it is possible to set a programme and to enter the user mode. In user mode, the following settings can be changed: • The level of the water softener according to the water hardness. • The activat...

Page 9 - BEFORE FIRST USE

than 21°dH, you can set the lowest water softener level. It deactivates the salt refill indicator. If you use standard detergent or multi- tablets without salt, set the proper water hardness level to keep the salt refill indicator active. How to set the water softener level The appliance must be in ...

Page 10 - DAILY USE

7.1 The salt container CAUTION! Only use salt specifically designed for dishwashers. The salt is used to recharge the resin in the water softener and to assure good washing results in the daily use. How to fill the salt container 1. Turn the cap of the salt container counterclockwise and remove it. ...

Page 12 - HINTS AND TIPS; General

Cancelling the programme Press and hold the programme button until the appliance is in programme selection mode. Make sure that there is detergent in the detergent dispenser before you start a new programme. End of the programme When the programme is completed theindicator is on. 1. Press the on/off...

Page 13 - CARE AND CLEANING

9.3 What to do if you want to stop using multi-tablets Before you start to use separately detergent, salt and rinse aid do the following procedure. 1. Set the highest level of the water softener. 2. Make sure that the salt and rinse aid containers are full. 3. Start the shortest programme with a rin...

Page 15 - TROUBLESHOOTING

10.2 Cleaning the spray arms Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object. 10.3 External cleaning • Clean the appliance with a moist soft cloth. • Only use neutral detergents. • Do not use abrasive products, abras...

Page 17 - The washing and drying results are not satisfactory

Refer to "Before first use" , "Daily use" , or "Hints and tips" for other possible causes. Once you have checked the appliance, deactivate and activate the appliance. If the problem occurs again, contact an Authorised Service Centre.For alarm codes not described in the table,...

Page 18 - TECHNICAL INFORMATION; ENVIRONMENT CONCERNS

Problem Possible cause and solution There are residues of deter-gent in the dispenser at theend of the programme. • The detergent tablet got stuck in the dispenser and therefore was not completely washed away by water. • Water cannot wash away the detergent from the dis- penser. Make sure that the s...

Table of Contents:

Summary

Other AEG Models