AEG CHDE3160ML/GB- User Manual

6 E E E Filter Version • The air is filtered through a charcoal filter and returned to the kitchen. • You will need an original AEG charcoal filter for the filtering function. (Available from your local AEG Service Force Centre). • Remove the grease filters, first pull the handles upwards, then extr...

7 Control Panel • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated.Turn the hood on a few minutes before you start cooking, you willthen get an under pressure in the kitchen. The hood should be lefton after cooking for about 15 m...

8 Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood • Clean the outside of the hood using a damp cloth and a mild deter- gent. • Never use corrosive, abrasive or flammable cleaning products.• Never insert ...

9 Dishwasher Place grease filters in dishwasher. Select the most powerfulwashing programme and highest temperature, at least 65°C.Repeat the process. Refit the grease filters when they are dry.When washing the metal grease filter in the dishwasher a slightdiscolouration of the filter can occur, this...

10 Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are thereforestrongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappro...

11 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that:The hood is connected to theelectricity supply.Check that the fan speed control isset to 1, 2 or 3. The cooker hood is not working Check that...

13 Guarantee conditions Guarantee ConditionsAEG offer the following guarantee to the first purchaser of this appliance.1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified bypurchase invoice or similar documentatio...

15 Technical Specifications Dimensions: (in cm):Height 40 Width 59,9 Depth 27 Maximum absorbed power: 200 W Motor absorption: 120 W Lighting: 2 x 40 W Length of the cable: 150 cm Mounting accessories included 1 Flange Ø 100 mm1 Flange Ø 120 mm2 Hooks2 rails1 Deflector2 Washers4 wood-screws 5 x 45 mm...

17 Installing the hood to the wall It is possible to fix the hood in position, if necessary, by only attachingit to the rear wall. Proceed as follows: • Drill four Ø 8mm holes on the wall as indicated. Fig. 10. • I n s e r t t h e f o u r w a l l p l u g s s u p p l i e d i n t o t h e s e h o l e s...

18 • Fix the base spacer M to the wall with the two screws R 5x45 provided using either the long or the short arm, depending on thedepht of the side cupboards. Do not tighten the screws fully. Fig. 11. • F i x t h e h o o d t o t h e w a l l b y m e a n s o f t h e t w o h o o k s P p r e v i o u s ...