AEG 6561G-M- User Manual

Page 3 - For the installer; Table of contents

3 Contents Page no For the user Your new appliance ...................................................................................... 2 Safety information ........................................................................................ 4 Description of the product ..........................

Page 4 - Safety information

4 Safety information These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. Your safety is of paramount importance. If you are unsure about the meaning of these warnings contact the Customer Care Department for assistan...

Page 6 - Description of the product

6 Description of the product Gas burner Control knob Air intake

Page 7 - How to use

7 How to use Burner markings Symbols at each operating knob indicate which burner is adjusted with the control knobs. Left front burner Left back burner Right back burner Right front burner Panel markings Each operating knob has a ring showing the scale of markings. Off. Maximum flame Minimum flame

Page 9 - Ignition

9 Ignition 1. Depress and turn the control knob for the burner to the left to max. flame . (Ignition position)2. The ignition electrode will emit sparks, and when the mixture of gas and air is correct, the burner will be ignited. If it is not possible to connect the unit to mains, a match may be use...

Page 10 - Maintenance and cleaning

10 Maintenance and cleaning For reasons of hygiene and safety, the cooking zones must be kept clean. Grease stains and spilled food generate smoke when heated, and can even cause fire. The splashguard can be removed to make it easier to clean the surface. What to do:1. Hold the splashguard as shown ...

Page 13 - Mounting

13 Caution: In order to avoid a hazard this appliance must be installed according to these instructions for installation The hob unit can be mounted in any type of kitchen with a table surface whose thickness is between 28 mm and 40 mm. Fixing Screw the fixing brackets out to such an extent that the...

Page 19 - Technical data

19 Cable type: 0,75 mm² HO5 V2V2-F The Dropinett must be connected via an external switch with a contact gap of min. 3 mm (the main switch may be used) Wiring Type of gas Adjusted to natural gas: G20 - 20 mbar Category and pressures II2H3B/P Convertible to Bottled gas - G30 - 30 mbar Max. nominal lo...

Page 20 - Service

20 Service If the hob is not working correctly, please carry out the following checks before contacting your local AEG Service Centre. IMPORTANT: If you call out an engineer to a fault caused by incorrect use or installation, a charge will be made even if the hob is under guarantee. If after all the...

Table of Contents:

Summary

Other AEG Models