AEG 35773G-M- User Manual

6 1. Rapid Burner 2. Semi-rapid Burners 3. Triple-crown Burner 4. Auxiliary Burner Description of the Hob Installation Any gas installation must be carried out by a qualified installer, and in accordance with existing rules and regulations. Please, ensure that, once the hob is installed, it is easil...

7 Hob Burners To light a burner, turn the relevant control knob anticlockwise to the maximumposition ( ), then push it down to ignite the burner. Upon ignition, keep the knob pushed down for about 5 seconds. This will allow the "thermocouple" to be heated and the safety device to be switched...

8 Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. The Hob Top Regularly wipe over the hob top using a soft cloth well wr...

9 Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local AEG Service Force Centre. SYMPTOM n There is no spark when lighting the gas n The gas ring burns unevenly SOLUTION u Check that the unit is plugged in and the electrical s...

10 OVERALL DIMENSIONS Width: 680 mm. Depth: 510 mm. Height: 15 mm. Weight: 14,5 Kg. CUT OUT DIMENSIONS Width: 560 mm. Depth: 480 mm. Thickness: 30 mm. HEAT INPUT Central Burner (triple-crown) 4,0 kW Rear Left Burner (rapid) 2,8 kW Natural Gas G20 - 20 mbar 2,8 kW L.P.G. G30/G31 28-30/37 mbar Rear Ri...

12 Installation l The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. l The side walls of the unit in which the hob is going to be installed must not exceed the height of the working top. l Avoid install...

13 Building In A = Auxiliary burner SR = Semi-rapid burner R = Rapid Burner UR = Triple crown burner Fig. 2 510 680 A SR SR R UR These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in Fig. 2. Installation and Assembly These hobs ...

17 Electrical connections The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support...

18 Injectors replacement • Remove the pan supports. • Remove the burner's caps and crowns.• With a socket spanner 7 unscrew and remove the injectors (Fig. 12), and replace them with the ones required for the type of gas in use (see tables - pag. 11). • Reassemble the parts, following the same proce-...