AEG 2972-6 i- User Manual

6 Remove transport packaging The appliance and the interior fittings are protected for transport. ¥ Remove all adhesive tape and packing pieces from the interior of the appliance. You can remove any remnants of adhesive using white spirit. Warning! Before disposing of old appliances make them inoper...

Starting up and temperature regulation Wash the inside of the appliance with lukewarm water with a littlebicarbonate of soda added (5ml to 0,5 litre of water). Do not use soapor detergent as the smell may linger. Dry the appliance thoroughly. ¥ When the refrigerator compartment door is opened, the i...

8 Interior Accessories Storage shelves ¥ You should always slide one of the full size glass storageshelves into the lowest set ofguides, above the fruit andvegetable containers, andkeep it in this position. ¥ The height of the storage shelves can be adjusted: ¥ To do this pull the storage shelf forw...

10 ¥ Allow warm food to cool down before freezing. The warmth will cau- se increased ice formation and increase the power consumption. ¥ Please note the maximum storage times specified by the manufac- turer. ¥ Thawed foods which have not been processed further (cooked into meals) may not under any c...

11 Preparation of Ice Cubes 1. Fill the ice cube tray 3/4 full with cold water, place it in the freezercompartment and leave to freeze. 2. To loosen the frozen cubes, either twist the ice cube tray or hold itunder running water for a few seconds. Important! Never try to free an ice tray that is froz...

12 Switching off the appliance To switch off the appliance, turn the temperature regulator to position"0" or disconnect from the electricity supply. If the appliance is not going to be used for an extended period: 1. Remove all refrigerated and deep-frozen packages as well as icetrays. 2. Re...

13 Cleaning and Care For hygienic reasons the appliance interior, including interior acces-sories, should be cleaned regularly. Warning! Before carrying out any cleaning or maintenance, disconnect theappliance from the electricity supply. ¥ Never clean the appliance with a steam cleaner. Moisture co...

14 Symptom Possible Cause Remedy Appliance does not work. Appliance is not switched on Switch on the appliance. Mains plug is not plugged inor is loose. Insert mains plug. Fuse has blown or is defec-tive. Check fuse, replace ifnecessary. Socket is defective. Mains malfunctions are to becorrected by ...

16 Changing the light bulb Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it. Light bulb data:220-240 V, max. 15 W 1. To switch off the appliance, turnthe temperature control knob toposition "0". 2. Unplug the mains plug. 3. T...

17 Service and Spare Parts If you require a service engineer or wish to purchase spare parts,contact your local AEG Service Force Centre by telephoning: 0870 5 929929 Help us to help you Please determine your type of enquiry before telephoning. When youcontasct us we need to know: 1.Your name, addre...

18 Guarantee Conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purcha-se invoice or similar document...

19 Installation Electrical Connection Any electrical work required to install this appliance should be carriedout by a qualified electrician or competent person. WARNING Ð THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety mea-sures not be observed. Before swi...

20 Installation Location The appliance should be set up in a well ventilated, dry room. Energy use is affected by the ambient temperature. The applianceshould therefore Ð not be exposed to direct sunlight; Ð not be installed next to radiators or other sources of continuous heat; Ð only be installed ...