Page 2 - Contents
2 Contents Introduction 3 Extraction mode 3 Recirculation mode 4 Electrical connection for UK 5 Technical details 6 Installation 7 Safety warnings for kitchen unit installer 7 Wall mounting 9 Hood operation 1 1 Safety warnings for user 1 2 Maintenance and care 1 3 Opening the grid 1 3 Grease filter ...
Page 3 - Introduction; Extraction mode
3 2 Introduction Extraction mode ● The hood is supplied as an extractor unit and can also be used as a filtered function (recirculation) by fitting activated carbon filters (available as an accessory). ● The unit features two outlet holes, one of which A is located on the top of the unit while the o...
Page 5 - Electrical connection for the UK; Appliances with 2 wires
5 Electrical connection for the UK Appliances with 2 wires WARNING: DOUBLE INSULATED - DO NOT EARTH The appliance must be connected to fixed wiring with a double pole switched fused spur outlet with or without pilot lamp. We strongly recommend the appliance to be connected only by a qualified electr...
Page 6 - Technical details
6 Technical details DimensionsHeight x Width x Depth (in cm) 69-113 x 59.9 x 51 Weight Net: 11,5 kg Gross: 12,6 kg Maximum absorbed power: 205 W Motor absorption 1 x 125 W Lighting: 2 x 40 W Length of the cable: 110 cm Fan powers (speed), speed in compliance with DIN 44971 Extraction mode 1 115 m 3 ...
Page 7 - Installation; Safety warnings for kitchen unit installer
7 Installation Safety warnings for kitchen unit installer ● When used as an extractor unit, the hood must be fitted with a 100 or120mm diameter hose. ● If the fumes must be forced out through the wall, you must obtain a MKZ sizable wall exhaust pipe (with external exhaust and air intake), E-Nr.- 610...
Page 9 - Wall mounting
9 Wall mounting ● Fix the drilling template to the wall. ● Make 3 Ø 8mm holes in the wall 2 at points I , 1 as desired at points L . ● Insert the three Ø 8mm expansion plugs into the wall. ● Insert 2 5x45 screws at points I but do not tighten them completely. ● Adjust the unit so that it is position...
Page 11 - Hood Operation; Fixing the shelf
11 Hood Operation ● The hood is fitted with a variable speed motor. The most effective use of the hood is obtained by switching it on a few minutes before you start cooking and leaving it on for approximately 15 minutes after you have finished, thus ensuring all cooking odours are eliminated. The co...
Page 12 - Safety warnings for user
12 ● Never leave a cooking hob or ring on without a pot or pan on top of it, to avoid the possibility of excess heat damaging the unit. Gas, oil or coal cooker flames in particular should never be left uncovered. ● Special care should be taken when using deep fat fryers since the oil in them can ove...
Page 13 - Maintenance and care; Opening the grid
13 10 Maintenance and care ● The hood must always be disconnected from the mains power supply before beginning any maintenance work. Opening the grid ● Open the latch L and swing the grille downwards. Fig. 10. ● To remove the grid, pull it forwards from the right and release it. Grease filter ● Th...
Page 15 - Cleaning
15 Warning ● Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. Changing the light bulb ● Disconnect the unit from the mains power supply. ● Remove the grid. ● Replace the ol...
Page 16 - Special accessories
16 Special accessories MKZ telescopic wall pipe E-Nr. 610 899 004 outlet hose ABS100 942 118 610 100 mm Ø outlet hose ABS120 942 118 611 120 mm Ø Metal grease filter MFF2 942 118 633 Carbon filter KFF 942 118 629
Page 17 - Something not working
17 Something not working If your cooker hood fails to work properly please carry out the following checks. Sympton Solution The cooker hood will not start... The hood is connected to the electricity supply. Check that the fan speed control is set to 1, 2 or 3. The cooker hood is not working The fan ...
Page 18 - Service & Spare Parts
18 Service & Spare Parts If you require a service engineer or wish to purchase spare parts, contact your local AEG Service Centre, by telephoning: 0990 929929 Help us to help you Please determine your type of enquiry before telephoning. When you contact us we need to know. 1. Your name, address ...