AEG 10648 - Manual
AEG 10648 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – IMPORTANT SAFETY INSTRUCTIONS; Installation Instructions; For Your Safety
- Page 3 – Pre-Installation Checklist
- Page 4 – with Microwave models only; For JKP90 model only.
- Page 7 – Electrical Connections; ATTENTION INSTALLER
- Page 8 – B4 Three-Conductor Branch; B3 New Construction and
- Page 9 – Securing the Oven in the Opening
- Page 11 – Replacing the Oven Door
- Page 12 – Operation Checklist; WARNING
- Page 13 – Antes de empezar; IMPORTANTE; Materiales necesarios; Partes incluidas
- Page 14 – Instrucciones de instalación; Para su seguridad; Requisitos eléctricos
- Page 15 – Lista de control antes de la instalación
- Page 16 – con microondas solamente; Para el modelo JKP90 solamente.
- Page 19 – Conexiones eléctricas
- Page 20 – B4 Conexión de circuito ramal
- Page 21 – Posición firme del horno en la abertura
- Page 23 – Cómo instalar la puerta del horno
- Page 24 – Lista de control antes de la prueba
1
If you have questions, call 1.800.GE.CARES or visit our website at:
ge.com
Built-In Wall Oven
with Microwave
27
”
(68.6 cm) model
Installation
Instructions
Before You Begin
Read these instructions carefully and completely.
•
IMPORTANT
—Save these
instructions for local inspector’s use.
•
IMPORTANT
—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
• NOTE—This appliance must be properly
grounded.
•
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
31-10648
02-07 JR
Tools Needed
1/8
”
Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
Parts Included
(Appearance will vary.)
Screws For
Installation
(8-18 x .750
flat head Phillips
wood screws)
27
″
(68.6 cm)
Metal Bottom Trim
30
″
(76.2 cm)
Metal Bottom
Trim Assembly
JKP90
30
”
(76.2 cm) models
JTP90, PT970
Optional 27
″
(68.6 cm) Metal
Bottom Trim
Assembly (on
some models or
can be purchased
separately)
Materials Needed
Strain Relief Clamp
for 1/2
”
conduit
Junction
Box
Wire Nuts
36
”
(91 cm)
of String
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for AEG 10648
Summary
2 IMPORTANT SAFETY INSTRUCTIONS Installation Instructions For Your Safety • Be sure your oven is installed properly by a qualified installer or service technician. • Be sure the oven is securely installed in a cabinet that is firmly attached to the housestructure. Weight on the oven door couldcause ...
3 Open oven door and remove literaturepack and oven racks. Open microwavedoor and remove shelves and turntablepackage. Remove Installation Instructionsfrom literature pack and read themcarefully before you begin. Be sure to place all literature,Owner’s Manual, Installations, etc.in a safe place for ...
4 Cabinet Width 27 ” (68.6 cm) RecommendedCutout Locationfrom Floor 21 5/8 ” (54.9 cm) Cutout Depth 23 1/2 ” (59.7 cm) Cutout Width 25 ” (63.5 cm) Min. 25 1/4 ” (64.1 cm) Max. Cutout Height 41 1/8 ” (104.5 cm) Min. 41 1/4 ” (104.8 cm) Max. If the cabinet does not have a solid bottom,two braces or ru...
