Addonics Technologies ADSAIDE44 - Manual
Addonics Technologies ADSAIDE44 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
ADDONICS TECHNOLOGIES
Model: ADSAIDE44
Installation Guide
Front View
Jumper Settings
Master
Slave
Cable Select
Note:
To set the SATA hard drive as a Master Device
when connected to an IDE channel, you need to
short the top pins located on the converter by
placing a jumper. As a Slave Device short the
middle pins.
1.
Locate the SATA connector of your 2.5” SATA drive.
2. Connect the converter board to the SATA connector of
the hard drive.
3. (Optional) Connect the IDE ribbon cable to the 44-pin
connector on the converter. The red edge of the ribbon
cable needs to line up to pin 1 marker of the 44-pin
connector. The other end of the ribbon cable will be
connec
ted to your motherboard’s 44-pin IDE channel.
TECHNICAL SUPPORT
Email:
http://www.addonics.com/sales/
Internet:
http://www.addonics.com
Technical Support
(8:30 am to 6:00 pm PST)
Phone: 408 573-8580
Email:
http://www.addonics.com/support/ticketid/
44-pin IDE Connector
SATA Power and
Data Connector
Master, Slave &
Cable Select
Jumpers
Pin 1 Marker
15-pin SATA Power &
7-pin Data Connector
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
