Addonics Technologies AD2SAHDCF - Manual
Addonics Technologies AD2SAHDCF – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Recommendations on using the; AD2SAHDCF as a boot device; SATA; the
- Page 3 – detects th e 2 CF cards in the AD2SAHDCF.
- Page 4 – Once Rebuild is done, this is the result.; Technical Support; OPERATING SYSTEM – What version of Windows; Contact Information
Addonics
T E C H N O L O G I E S
Dual CF-SATA HDD Adapter
Model: AD2SAHDCF
User’s Guide
Version 1.0
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interfer ence to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is
connected
Consult a certified television or radio technician
Overview
Note:
The default setting for the RAID setting is
BIG. The
switch has 3 settings. You slide the switch
from left to right to change RAID setting.
SATA Power
Connector
2.5” form
factor bracket
CF Slot 2
CF Slot 1
USB Port
SATA Data
Connector
Switch
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Recommendations on using the AD2SAHDCF as a boot device The CF cards plug into the AD2SAHDCF can be configured as your boot drive. It is recomm ended that the CF cards be configured as a raid set first by connecting it as an external device. Steps: 1. 57xx SteelVine Manager Utility Installation Note...
Steps to configure a SAFE RAID set using USB connection (Windows XP) 1. Open the 57xx SteelVine Manager. 2. Insert the 2 CF cards to the CF slots on the AD2SAHDCF. 3. Connect the USB cable to the AD2SAHDCF. The 57xx SteelVine Manager detects th e 2 CF cards in the AD2SAHDCF. 4. Open Disk Management ...
8. To rebuild the SAFE RAID set, go to Action > Start Rebuild > Drive 1 Once Rebuild is done, this is the result. Note: The steps for creati ng BIG or FAST RAID set would be similar with the steps on creating SAFE RAID set. Only select the correct switch setting. Technical Support If you need ...
