Adder X100 - Manual

wel c ome c ontent s inst all ation & op era tion sp ecial c onfigura tion fur t  er informa tion Installation & Operation Connections Installation of the X100 modules is straightforward and minimal configuration requirements in most cases. The moulded CAM ( Computer Access Module ) connect...

wel c ome c ontent s inst all ation & op era tion sp ecial c onfigura tion fur t  er informa tion Operation General use In use, the X100 modules should be transparent - the system and its peripherals should operate exactly as normal, the only difference being that they are now up to 100 metres ...

wel c ome c ontent s inst all ation & op era tion sp ecial c onfigura tion fur t  er informa tion Special configuration Configuration You can alter the way that the X100 modules operate to suit your requirements. This is done using the Configuration mode and you can affect the following setting...

wel c ome c ontent s inst all ation & op era tion sp ecial c onfigura tion fur t  er informa tion 0 Password setting Password protection allows you restrict access to the system only to authorised personnel. A password first needs to be set and then, using the keyboard attached to the remote X1...

wel c ome c ontent s inst all ation & op era tion sp ecial c onfigura tion fur t  er informa tion Hot plugging and mouse restoration It is strongly recommended that you switch off the computer system before attempting to connect it via the X100 modules. However, if this is not possible then you...

wel c ome c ontent s inst all ation & op era tion sp ecial c onfigura tion fur t  er informa tion To apply remote user video compensation 1 On the keyboard that is connected to the X100 remote module, simultaneously, press the hotkeys (by default, and ) along with to enter configuration mode. T...

wel c ome c ontent s inst all ation & op era tion sp ecial c onfigura tion fur t  er informa tion Miscellaneous settings The following are configuration settings within the modules that are not covered in other sections of this guide. These can be achieved once within configuration mode by pres...

wel c ome c ontent s inst all ation & op era tion sp ecial c onfigura tion fur t  er informa tion Performing flash upgrades The Adder X100 modules and CAMs are fully reconfigurable via flash upgrades using the kVM Firmware Uploader utility. during the upgrade you will be required to connect the...

wel c ome c ontent s inst all ation & op era tion sp ecial c onfigura tion fur t  er informa tion 5 Further information Getting assistance • Adder.Technology.website – www.adder.com Check the Support section of our website for the latest solutions and driver files. • Email – [email protected] •...

wel c ome c ontent s inst all ation & op era tion sp ecial c onfigura tion fur t  er informa tion 6 Warranty Adder Technology Ltd warrants that this product shall be free from defects in workmanship and materials for a period of two years from the date of original purchase. If the product shoul...

wel c ome c ontent s inst all ation & op era tion sp ecial c onfigura tion fur t  er informa tion Radio Frequency Energy A Category 5 (or better) twisted pair cable must be used to connect the units in order to maintain compliance with radio frequency energy emission regulations and ensure a su...