Accusplit 1120M2 - Manual

WEARING YOUR PEDOMETER

While gently holding the belt clip open, slide the pedometer

onto your belt or the top edge of your pants or skirt. It should

fit snugly and level, above one knee.

Note:

The pedometer should be as vertical as possible.

W

alkers with larger stomachs may find it helpful to wear the

pedometer farther back on the body, toward one hip.

T

o avoid losing or dropping your pedomete

r, use the included

leash and clip to fasten the pedometer securely to your

clothing.

Attaching the Leash:

Attach the pedometer to the leash by

looping the leash around the pedometer belt clip. Next, clasp

the waistband of your clothing with the attached clip. You can

also use a safety pin to fasten the leash to your clothing, loop

the leash through your belt or belt loop, or use a badge holder.

VIEWING YOUR RESULTS

Once you put on your pedometer, it will automatically begin

to record your steps. Press the DAY

button to view today’s

step count. Press the TOTAL

button to view total steps taken.

MEMORY PEDOMETER

OPERATING INSTRUCTIONS

ACCUSPLIT

, Inc. • 3090 Independence Drive, Suite 148 • Livermore, CA 94551 USA

800-935-1996 • 925-290-1900 • FAX 925-290-1930 •

www.ACCUSPLIT

.com • support@ACCUSPLI

T

.com

ACCUSPLIT®

EAGLE

™

1120M2

Congratulations on taking the

fi

rst step to wellness with your purchase of an ACCUSPLIT

pedometer. It

’

s easy to set up your new pedometer. Just follow the steps below, and start walking!

RESETTING YOUR PEDOMETER

Most people prefer to reset step counts daily.

To reset: While displaying

Day’

s Steps, press and hold DAY

button for at least three seconds to reset to zero. When

displaying Total Steps, press TOTAL button for three seconds

to reset Total and

Day’

s Steps to zero.

AUTO MOVEMENT SENSOR

1. T

o filter out random movements, the unit remains in standby

mode until 5 continuous steps are registered. Only then are

the 5 steps calculated in, and an

Active indicator “

▲

” appears

on the upper left of display.
2.

When regular walk/run movement stops, after 2 seconds the

timer pauses and the unit switches to standby status (Active

indicator “

▲

” disappears).

REPLACING THE BATTERY

When the display starts to dim or goes blank, it is time to replace

the battery. Your pedometer uses one Type L1142 (LR43) 1.5

volt silver oxide batter

y. To replace:

1. Using a jeweler

’

s screwdri

v

er, loosen small screw on back of

unit. Remo

v

e back of case.

2. Slide the old battery gently out of its holder. Replace it with a

new battery.

The battery’s positive (+) terminal should be

FACE UP while you put it into the pedometer.
3. Gently press front and back of pedometer case back together,

being sure to line up slots and tabs at top and bottom of unit.

ACCUSPLIT

EAGLE

1 1 2 0 M 2

T W 1 5 M G

T

O

T

A

L

D
A
Y

AccuSTEP

10000.org

ST

TL

MODES

• “D”– “Day’s Steps”

Counts steps taken since last RESET.

• “T”–”Total Steps”

Keeps track of all steps taken, even after

Day’s Steps are reset.

DAY button

TOTAL button

970-043

First, loop the

pedometer clip

Next, loop the metal

clip, then clasp clothing

Or, loop a

badge holder, then

put into pocket

(Badge holder

not included)

Or, loop a belt

or belt loop

REGISTER NOW

Please return

your AE1120M2 Registration to
the Repair Center address in the
warranty, and we will let you
know about future products.

Email (preferred)
User