Page 3 - Operator’s Guide; Super Close Projection System SCP725; IS; Contents; Introduction
3 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Contents Introduction Thank You for Choosing 3M Equipment ...................................................................................................... 5Trademarks ........................
Page 5 - Thank You for Choosing 3M Equipment
5 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Introduction Thank You for Choosing 3M Equipment This product has been produced in accordance with 3M’s quality and safety standards to provide smooth and trouble free use in the years to come. ...
Page 7 - What 3M Will Do To Correct Problems:; Product Patents; Instructions to Users:
7 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H What 3M Will Do To Correct Problems: • If your 3M Product requires service, 3M will ask you to bring or send the 3M Product, securely packaged in its original container or equivalent, along with...
Page 8 - Low Voltage Directive:
8 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H CE STATEMENTElectromagnetic Compatibility Statement: Meets 2004/108/EC Directive Low Voltage Directive: Meets 2006-95-EC Directive. WEEE STATEMENT: The following information is only for EU-membe...
Page 9 - Safety Information; projector. Retain these instructions for future reference.; Intended Use; Altitude; result in death or serious injury and/or property damage.; Warning: Hazardous Voltage
9 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Safety Information Please read, understand, and follow all safety information contained in these instructions prior to the use of this projector. Retain these instructions for future reference. ...
Page 10 - WARNING; To reduce the risk associated with hazardous voltage:
10 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H m WARNING To reduce the risk associated with hazardous voltage: • Do not operate this projector in wet environments or outdoors. • Do not modify this projector or power cord. • Do not remove an...
Page 11 - CAUTION; SAVE THESE INSTRUCTIONS
11 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H m CAUTION To reduce the risk associated with eye strain, nausea, dizziness, headache: • Take a break every hour for 15 minutes. • Do not view 3D images or 3D full motion videos while standing o...
Page 12 - The following safety labels are used on this product.
12 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Safety Labels The following safety labels are used on this product.
Page 13 - Contents of Shipping Box; Keep Your Packing Materials; Center for repair. Use packing material to protect projector.
13 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Contents of Shipping Box This projector is shipped with the necessary cables required for standard DVD player, PC or laptop computer connections. Carefully unpack and verify that you have all o...
Page 14 - Product Description; Machine Characteristics
14 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Product Description The 3M SCP725 integrates short-arc lamp and Digital Light Processing™ (DLP) technology. It accepts input from computer and/or video sources and projects a bright image throu...
Page 15 - the chart above for the offset values.
15 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Projector Distance from Screen and Image Size Refer to the chart below for the projector-to-screen distance and corresponding projected image size values. Image Size Distance (D) Offset Min (S)...
Page 16 - Projector Panel
16 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Parts Identification 1. Super Close Projection Lens2. Focus Adjustment3. Lens-shift4. Remote Control IR Sensor5. Status Indicator Light6. Standby/On Button7. Lamp Cover8. Ventilation Slots9. HD...
Page 17 - I/O Module Control Panel Function; Top Terminal Panel on I/O Module; Top Terminal Panel
17 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H I/O Module Control Panel (optional accessory) If your projector has the optional I/O Module installed, the projector functions can be operated from the I/O Module Control Panel. 4 3 5 6 1 2 # I...
Page 18 - Bottom Terminal Panel
18 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Bottom Terminal Panel on I/O Module Use the Bottom Terminal Panel to connect the I/O Module box to the Computer/Video source. I/O Module 7 8 9 10 11 12 13 1 2 3 4 5 6 # Bottom Terminal Panel Fu...
Page 19 - ENGLISH; Remote Control Functions
19 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. ENGLISH ON/STANDBY ON: Press to turn projector ON. OFF: Press to display confirmation message, press again to switch projector to Standby mode. Note: The confirmation message displays to ensure unit does no...
Page 20 - Installing Batteries in Remote Control; Setup and System Configuration
20 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. ENGLISH Installing Batteries in Remote Control 1. Push down on cover to unlatch it. Slide cover off. 2. Install same type of batteries with the correct polarities. 3. Reinstall battery cover. Note: Verify t...
Page 21 - Operating Instructions; Projector Start Up; PIN Code; Stand By Mode
21 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Operating Instructions Projector Start Up Read the Important Safeguards before operating the SCP725. After all cable connections have been completed, refer to Setup and Configuration, the proje...
Page 22 - Menu Navigation; to display the desired submenu.; – Select the desired computer or video input source.
22 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Menu Navigation To display the on screen menus, press the MENU button on the remote control or I/O Module. Use the remote control Up/Down ARROW buttons to select the desired menu (see table bel...
Page 23 - Feature; Main Input
23 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Input Menu The Input Menu, shown below, is used to select the desired computer or video input source to be displayed on the projector. Input Input Source: Computer 1 Computer 1 / Component 1 Co...
Page 25 - (Only for Computer 1 or Computer 2 input source)
25 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Advanced Picture Menu The Picture Menu with the Advanced option selected, shown below, is used to adjust the projected image for Computer and Component inputs only. Picture Input Source: Comp...
Page 27 - See Information Menu
27 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Setup Menu The Setup Menu, shown below, is used to configure the basic projector operating parameters. Setup Input Source: Computer 1 Language English Auto Shutoff Minutes Off |··········· ...
Page 28 - Note: When PIN security is enabled, the PIN access
28 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Advanced Setup Menu The Advanced Setup Menu, shown below, is used to initiate the PIN code feature (turn On/Off) and set the PIN code. Advanced Setup Input Source: Computer 1 PIN Authenticati...
Page 30 - Machine Specifications; Item
30 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Machine Specifications Item Specification Acoustic Noise Level Bright Mode: Typical 34 dB(A) Normal Mode: Typical 32 dB(A) ECO Mode: Typical 28.5 dB(A) Auto Detect & Install Automatically r...
Page 31 - Maintenance; Lamp Replacement; Hg
31 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Maintenance Lamp Replacement www.lamprecycle.org Hg 11 10 6 12 1 2 3 4 5 7 8 9 Note: Refer to the Setup Menu to reset the lamp hour timer after replacing the lamp. E N G L IS H
Page 33 - Vacuum the lamp cavity to remove all dislodged dust.
33 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Cleaning the Lamp Module and Lamp Compartment For best lamp performance, there must be adequate air flow through and around the lamp module. A build up of dust or dirt will reduce the air flow ...
Page 34 - Replace the lamp door and secure it with the retaining screws.
34 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H 4. Install the lamp taking care to seat it fully into the lamp socket connection and tighten the lamp retaining screws. 5. Replace the lamp door and secure it with the retaining screws. 6. Veri...
Page 35 - Troubleshooting; Identifying an Expired Lamp Module; Lamp Module Parts; brightness is inadequate.
35 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Troubleshooting Identifying an Expired Lamp Module Lamp Module Parts 1 2 3 3 1 2 3 4 5 1. Top of Lamp Module2. Lamp Connector3. Air Vents4. Lamp Wires5. Bulb Envelope - This is the shape of the...
Page 37 - Symptom
37 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Symptom Standby Button State Possible Cause Action The lamp will not ignite Red The projector is cooling down. Wait until the projector completes its cooling cycle. Once the Standby button turn...
Page 40 - Replacement Parts and Accessories; Replacement Parts; Name of Part
40 Operator’s Guide 3M ™ Super Close Projection System SCP725 © 3M 2011. All Rights Reserved. E N G L IS H Replacement Parts and Accessories Replacement Parts Name of Part 3M Part Number VGA Cable, 1.8 m 78-8134-7029-7 Remote Control 78-8134-7200-4 SCP725/SCP725W Lamp Replacement 78-6969-9996-6 Opti...
