3M 250/900 - Manual
3M 250/900 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Safety Precautions; Protective Eyewear; Chemical Precautions; Laser Safety
- Page 3 – Connector and Tool Diagram; The diagrams below show the parts of the 3M; No Polish ST Connector SM; Remove the dust cap from the front of the
- Page 4 – With the guide funnel fully forward, lay the fiber; 00 μm semi-tight buffer fi ber
- Page 5 – 0 seconds or a rate of 3 mm/sec
- Page 6 – Release and lift the fiber clamp and raise the doors to
- Page 7 – No Polish ST Connectors, Kit and Tool Descriptions; No Polish Connector Kit 8865-C with Cleaver
- Page 8 – M is a trademark of 3M Company.; Important Notice; your intended application.; M MAKES; Communication Markets Division
3M
™
No Polish ST Connector SM and MM,
Flat Splice, 250/900 µm
Instructions
3
November 2012
78-0013-6978-0-B
The Network of Networks.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
78-0013-6978-0-B 2 Safety Precautions Protective Eyewear CAUTION To reduce the risk associated with eye injury:| - Safety glasses should be worn when handling chemicals and cleaving the optical fiber. Chemical Precautions WARNING To reduce the risk associated with fire:- Storage, use and disposa...
78-0013-6978-0-B 3 1.0 Connector and Tool Diagram 1.1 The diagrams below show the parts of the 3M ™ No Polish ST Connector (singlemode pictured) and the 3M ™ No Polish ST Connector Assembly Tool 8835- AT. Please review these drawings to understand the instructions in the following pages. Carefully f...
78-0013-6978-0-B 4 2.3 Move the guide funnel forward on the fiber holder until it stops; open doors and fiber clamp. Funnel Door Bow Start Door Clamp Move forward Guide funnel 2.4 Strip, clean and cleave the fiber to 8 +/- 0.5 mm (.32 ± .02 inches) measured from the end of the 900 µm buffer. Use the...
