3M 2210E - Manual
3M 2210E – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS
- Page 3 – INTRODUCTION; Dynatel; INSTALLING OR REPLACING THE BATTERIES; Since regulations vary, consult applicable regulations
- Page 4 – INITIAL RECEIVER CONFIGURATION; and pressing; RECEIVER BATTERY TEST; When batteries are low, the battery test indicator
- Page 5 – TRANSMITTER BATTERY TEST; To test the Batteries, hold down; LOCATING A BURIED CABLE; Transmitter Setup; Key descriptions can be found inside the Transmitter lid.
- Page 6 – Normal; Transmitter setup is finished, now go to; panel jack while the red and black clips are connected to a cable.; Direct Connect Method
- Page 8 – Induction Method; For greater tracing range, select high output level by pressing
- Page 9 – Receiver Setup
- Page 10 – About Trace Modes; suspected cable path.
- Page 11 – DETERMINING CABLE DEPTH AND CURRENT; Determining ADP Depth; perpendicular
- Page 12 – LOCATING EMS MARKERS; Locating Markers while Tracing Cable Path; Alert; Locating Markers using the Receiver
- Page 13 – CABLE OR PAIR IDENTIFICATION; Cable Identification requires two Dyna-Couplers: one at the
- Page 14 – Press
- Page 15 – TECHNICAL INFORMATION; Transmitter; watts maximum; Receiver
- Page 16 – Important Notice; If this; Except where prohibited by law, 3M
September 1999
78-8097-6519-7-Revision B
Dynatel
™
2210E
Cable Locator
Operators Manual
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TABLE OF CONTENTS Introduction ............................................................................... 2Installing or Replacing the Batteries ........................................ 2Initial Receiver Configuration .................................................. 3Receiver Battery Test ......
INTRODUCTION The 3M ™ Dynatel ™ 2210E Cable Locator consists of a Transmitter and a Receiver for locating buried cables or Active Duct Probes (sondes). It alsocan be used to identify cables or pairs using a Dyna-Coupler plugged intothe Receiver jack. The Transmitter provides two frequencies toaccomm...
INITIAL RECEIVER CONFIGURATION Display depth units (inches, feet and inches, or centimeters) may bechanged while holding and pressing . For each press, one of three units will display. To change the passive Power frequency, press andhold then press to toggle between 50 or 60 Hz as displayed in the l...
