3Com II Hub 10 - Manual
3Com II Hub 10 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Network Connections; NTRODUCTION
- Page 4 – Front Panel; Out; iii
- Page 5 – Rear Panel Connection; Disconnect power from all units that will form part of the new
- Page 6 – Siting the Hub 10 Telco; Rack or Wall Mounting; Hub 10/FMS II only stacks; Managing with an FMS Management Module; Power Up; Spot Checks
- Page 7 – Products; Hub 10 management; Bulletin Boards; Wall Mounting Hub 10 Units; Rack Mounting Hub 10 Units
Related Standards
The Hub 10 Telco has been designed to conform to the following
standards:
Physical
Electrical
Hub 10 Telco only
Hub 10 Telco & Management Module
Environmental
T
ECHNICAL
I
NFORMATION
Functional
ISO 8802/3, IEEE 802.3
Safety
UL 1950, EN 60950, CSA 22.2 #950
EMC
EN 55022 Class B, EN 50082-1, FCC Part 15 Class A,
CSA C108.8 Class A
(screened cables must be used to ensure
compliance with these standards)
Environmental
EN 60068 (IEC 68)
Width
440mm (17.3 ins)
Depth
224mm (8.8 ins)
Height
44mm (1.7 ins) or 1U
Weight
2.6kg (5.7lb)
Mounting
free standing,
or 19" rack or wall mounted using kit supplied
Power Inlet
IEC 320
Fuse Protection
2 Amps
Power Consumption
22 VA
Power Dissipation
73 BTU/hr
Power Inlet
IEC 320
Fuse Protection
2 Amps
Power Consumption
30 VA
Power Dissipation
100 BTU/hr
Operating Temperature
0-50°C (32-122°F)
Humidity
0-90% (non-condensing)
SuperStack™ II Hub 10
Telco (3C16672A)
User Guide
DUA1667-2AAA03
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
The SuperStack™ II Hub 10 Telco (3C16672A) has two 12 port Telco connectors on the front panel providing Ethernet TP port connections, and an AUI port on the rear panel. The rear panel also has a slot for a 3Com Transceiver Module or Bridge MicroModule: if fitted the module will operate in addition ...
Front Panel 1 24 Telco Ports A range of Telco connectors can be used with the Hub 10 Telco. Refer to “ Introduction ” for more information. CAUTION: Do not over-tighten the screws on the Telco connectors. 2 MDI Switch The Media Dependent Interface (MDI) switch controls the operation of port 24. The ...
Rear Panel Connection 11 Power Supply and Fuse WARNING: Ensure that the power supply is disconnected before opening the fuse holder cover. The Hub 10 Telco automatically adjusts to the supply voltage. The fuse is suitable for both 110V A.C. and 220-240V A.C. operation. To change the fuse, release th...
