3Com 1000BASE - Manual
3Com 1000BASE – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Handling the Module; Installing the Module into a Switch; Removing the Module from a Switch; NSTALLATION
- Page 3 – The
- Page 4 – FCC Statement; Europe; LECTROMAGNETIC
- Page 5 – IMITED
- Page 6 – EGAL; Documentation Feedback
The SuperStack II Switch 1000BASE-T Module provides a
Gigabit Ethernet module for the SuperStack II Switch
1100 (12 and 24 port), SuperStack II Switch 3300 (12
and 24 port), and SuperStack II Switch 3300 FX.
The module requires management software version 2.42
or later to be installed on the Switch. For instructions on
upgrading management software, refer to the
documentation supplied with your Switch.
The module conforms to the full duplex implementation
of the Gigabit Ethernet standard IEEE 802.3ab. The
module supports a 100 m cable segment, using
Category 5 copper cabling and RJ-45 connectors, as
defined in the ANSI/TIA/EIA-568-A Commercial Building
Telecommunications Cabling Standard, and in the
1000BASE-T standard.
A white paper which describes 1000BASE-T technology
and cabling requirements in more detail is available from
the 3Com
®
Web site.
LEDs
You can gather information about the status of the
module and its packet activity using LEDs on the front of
the Switch and on the module itself.
I
NTRODUCTION
LED
Color
Indicates
Expansion Module Port Status LEDs
(located on the front of the Switch):
Packet
Yellow
Packets are being transmitted/received on
the module port.
Status
Yellow
A valid module is installed.
Yellow flashing
An unrecognized or faulty module is
installed.
Off
No module is installed.
Module Status LEDs
(located on the module at the rear of the Switch):
Packet
Yellow
Packets are being transmitted/received on
the module port.
Status
Green
Link present and port enabled.
Green flashing
Link present but port disabled.
Off
Link failed or disconnected.
1
SuperStack
®
II Switch 1000BASE-T Module
(3C16978)
User Guide
3C16978 SuperStack II Switch 1000BASE-T Module
®
DUA1697-8AAA01
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
WARNING : Installation and removal of the module must be carried out by qualified personnel only. Before installing the module into a unit, you must first disconnect the unit from the mains power supply. For full safety instructions, refer to the user guide that accompanies the unit. AVERTISSEMENT :...
The module requires management software version 2.42 or later to be installed on the Switch. For instructions on upgrading management software, refer to the documentation supplied with your Switch. Support for the management software is supplied by 3Com Transcend ® Network Control Services. When the...
T ECHNICAL S PECIFICATIONS 4 FCC Statement This equipment has been tested with a class A computing device and has been found to comply with part 15 of FCC Rules. Operation in a residential area may cause unacceptable interference to radio and TV receptions, requiring the operator to take whatever st...
